information concerning cutting that should be found in the job documentation or production control system OHS factors that must be considered when handling knife blades during the knife change operation? factors that indicate a new blade is needed problems arising from using a dull blade continuously identifying a sharp knife from a dull knife need to replace a cutting stick OHS factors that must be considered when setting up and operating the machine factors that should be considered when setting up a guillotine for cutting choosing correct clamping pressure for a given job OHS factors that must be considered when checking and adjusting the machine aspects of the cutting that result should be checked against the sample steps that should be taken if the cutting result does not coincide with the sample OHS factors that must be considered when maintaining the production process reporting procedures that should be followed if the machine malfunctions treat/dispose of guillotine waste part of the guillotine that should be checked if, after a cut, the top sheets are out-of-square? part of the guillotine that should be checked if, after a cut, the top sheets are creasing across the cut line? the need for machine lubrication information about correct types and methods of lubrication OHS factors that must be considered when shutting down or cleaning a machine special operations that are essential when shutting down the machine quality aspects that should be considered in a completed cutting job machine manuals, safety and other documentation that are relevant to this task and where they are kept documentation and information that is included in these documents
|