information concerning laminating requirements that you would expect to find in the job documentation or production control system interpretation of this information to ensure smooth workflow throughout the factory elements that must be considered when planning a laminating sample OHS areas that must be addressed when setting up these areas of the machine webbing procedures commonly used in the transportation area areas to consider when setting up the web control system problem areas likely to be encountered setting up the sheeter methods of splicing a web on the laminating process OHS areas that must be addressed when setting up the laminating machine checks to be made when setting up (and adjusting) the application system cylinder checks to be made when setting up (and adjusting) the adhesive application system factors that determine the setting of the binding pressures important matters that are to be examined when setting the drying system largest/smallest size sheet that can be processed on this machine adapting the machine to facilitate smaller/larger stock OHS areas that must be addressed when setting up these areas of the machine in-line units that are available for the laminating process OHS factors that should be considered before readjusting the machine circumstances that the machine would need to be adjusted quality aspects that should be considered in a completed laminating job steps that should be taken to ensure that important features of the production control system are addressed items to be checked against the client's sample machine manuals, safety and other documentation that are relevant to this task and where they are kept and information that is included in these documents
|