vital information missing from the job ticket checks that should be undertaken prior to set up (availability of materials etc) problems that can result from the cylinder not being cleaned prior to plate fitting how the grip edge of the plate is identified effect of over packing the printing plate cylinder pitch lines to be used to assist in plate installation tools or actions are likely to damage the plate plates be consistently tensioned OHS precautions that must be observed when webbing up the machine determining the printing side of the material effect of low web tension on the print purpose of nip rollers types of web splices appropriate for the job OHS factors that need to be considered when setting up the sheet in-feed and transfer systems sheet normally set up in the middle of the machine effect side lay selection has on the job determining the position of the sheet before it is transported to the printing unit how a register check would be carried out two-sheet cut used on most feeders sheet is missing or late effect of excessive web tension at the rewind of the machine risks associated with the rewind of the machine application of spray powder is sometimes advisable affects of too much spray powder slowdown devices to be used in the delivery effect excessive jogging would have on the stack OHS and environmental concerns of inks and additives details that are necessary to check the suitability of an ink for a job modifying ink that is slightly light methods that are available to check the ink for correct colour who passes the colour prior to running the job OHS factors that need to be considered when setting up the machine how the cylinder (plate, blanket and impression) specifications are determined for the specific job effects an incorrectly set dampening system may have on the job ink profile varies across the machine optimum ink duct sweep machine position to engage in-line processing units precautions necessary when setting up in-line processing units precautions to be taken if UV drying was utilised to dry the ink film methods that can be used to minimise waste during make ready check on the initial print prior to running how the machine is proof tested ideal conditions for inspecting the proof methods that are available to check and adjust ink colour and consistency adjustments that may have caused mis-register adjustments that are made to position the image laterally adjustments that are made to position the image circumferentially who has the final say in the "OK" of the job machine manuals, safety and other documentation that are relevant to this task and where are they kept and information that is included in these documents
|