This unit of competency defines the skills and knowledge required to prepare materials and carry out routine gas metal arc welding (GMAW) and applies in a maintenance or manufacturing environment where the weld quality is not required to meet an Australian Standard or equivalent.

Where welding is required to meet AS 1554 General Purpose or equivalent codes, work health and safety (WHS) regulations and/or licensing requirements unit MEM05017 Weld using gas metal arc welding process should also be selected.

Where the interpretation of technical drawings is required unit MEM09002 Interpret technical drawing should also be selected.

Where the selection and use of engineering measurement is required unit MEM12023 Perform engineering measurements should also be selected.

Where the selection and use of tools is required unit MEM18001 Use hand tools and unit MEM18002 Use power tools/hand held operations, should also be selected as appropriate.

No licensing, legislative or certification requirements apply to this unit at the time of publication.

Band: A

Unit Weight: 2

You may want to include more information here about the target group and the purpose of the assessments (eg formative, summative, recognition)

List each assessment task's title, type (eg project, observation/demonstration, essay, assingnment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

This field allows for different work environments and conditions that may affect performance. Essential operating conditions that may be present (depending on the work situation, needs of the candidate, accessibility of the item, and local industry and regional contexts) are included.
Welds include the following:	butt fillet
Materials include one (1) or more of the following:	low carbon mild steels
Prepared includes one (1) or more of the following:	pre-heating setting up jigs fixtures clamps joint preparation
Welding equipment includes the following:	hoses welding leads and gas shrouds gas regulators liners contact tips
Consumables include the following:	filler wire and shielding gas
Clean includes the following:	slag and spatter

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Follow standard operating procedures (SOPs)
Identify location of welds in accordance with procedures and job specifications
Weld materials to job requirements

Assessment Cover Sheet

MEM05050 - Perform routine gas metal arc welding

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

MEM05050 - Perform routine gas metal arc welding

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: