This unit describes the performance outcomes, skills and knowledge required visually inspect and fill SCUBA cylinders.

SCUBA cylinders are required to undergo cyclic inspection and can only be certified by a certified gas cylinder test station. This unit does not cover those specialist skills.

It applies to dive leaders, usually known as divemasters, or instructors and to assistant instructors and support staff.

This unit applies to any type of organisation that delivers SCUBA diving activities and dive instruction including commercial, not-for-profit and government organisations.

No occupational licensing, certification or specific legislative requirements apply to this unit at the time of publication.

You may want to include more information here about the target group and the purpose of the assessments (eg formative, summative, recognition)

List each assessment task's title, type (eg project, observation/demonstration, essay, assingnment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Operate high pressure compressor according organisational safety procedures and manufacturers' specifications.
Fill cylinders with air to correct capacity and pressure.
Refit valve and clean and dry areas.
Complete leak testing and documentation according to organisational requirements.
Handle, store and restrain cylinders according to organisational safety procedures.
Test organisation’s air purity regularly to ensure it meets standards.
Visually inspect cylinders prior to filling, according to organisational safety procedures and manufacturers' specifications.
Identify any non-compliant cylinders, tag and isolate from use according to organisational procedures
Remove cylinder boot and mesh, visually inspect exterior of cylinders for dents, gouges and corrosion.
Operate high pressure compressor according organisational safety procedures and manufacturers' specifications.
Fill cylinders with air to correct capacity and pressure.
Refit valve and clean and dry areas.
Complete leak testing and documentation according to organisational requirements.
Handle, store and restrain cylinders according to organisational safety procedures.
Test organisation’s air purity regularly to ensure it meets standards.

Assessment Cover Sheet

SISOSCB007 - Inspect and fill SCUBA cylinders

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

SISOSCB007 - Inspect and fill SCUBA cylinders

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: