This unit involves the skills and knowledge required to assess the gas and safety equipment on a delivery vehicle for the distribution of gaseous fuel in accordance with relevant legislation, codes of practice, regulations and workplace procedures.

It includes assessing gas and safety equipment on delivery vehicles by identifying faults, using workplace operating procedures, liaising with appropriate persons, and conducting inspections and tests.

This unit applies to work sites where the bulk distribution of liquefied petroleum gas (LPG) occurs using delivery vehicles, and subject to work health and safety (WHS)/occupational health and safety (OHS) and duty of care requirements being met for the workplace.

This unit is intended as an entry level unit, for new entrants in the gas industry. It is suitable for employment-based programs.

No licensing, legislative or certification requirements apply to this unit at the time of publication.

You may want to include more information here about the target group and the purpose of the assessments (eg formative, summative, recognition)

List each assessment task's title, type (eg project, observation/demonstration, essay, assingnment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

Range is restricted to essential operating conditions and any other variables essential to the work environment. Non-essential conditions may be found in the UEG Gas Industry Training Package Companion Volume Implementation Guide.
constants and variables must include the following:	appropriate persons delivery vehicles faults gas safety equipment inspection and testing workplace operating procedures workplace procedures workplace requirements
equipment must include at least six (6) of the following:	earthing straps emergency equipment gauges hoses and connections including hose protection systems hydraulic equipment meters pipes pneumatic/electronic control equipment pump and drive shaft seals and gaskets tanks, valves and fittings
equipment faults must include at least four (4) of the following:	damaged hoses electric control cable damage gas/air leaks oil leaks valves not operating water leaks
work practices must include the following:	apply basic planning skills apply safe manual handling techniques communicate effectively in the workplace identify and report faults maintain a safe and clean workplace operate equipment within its limitations respond to emergency situations work safely with hazardous materials and equipment work utilising relevant procedures

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Work instructions are obtained and confirmed in accordance with workplace procedures
WHS/OHS policies and workplace procedures and safe work practices are followed to eliminate or minimise incidents and hazards
Work undertaken is checked against work schedule and anomalies reported to authorised persons in accordance with workplace procedures

Assessment Cover Sheet

UEGNSG622 - Assess the operational capability of gas safety equipment on a delivery vehicle

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

UEGNSG622 - Assess the operational capability of gas safety equipment on a delivery vehicle

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: