8) This describes the essential skills and knowledge and their level, required for this unit. Evidence shall show that knowledge has been acquired of conducting single energy source isolation procedures. All knowledge and skills detailed in this unit should be contextualised to current industry practices and technologies. The extent of the Essential Knowledge and Associated Skills required follows: KS01-PO336B A gas turbine unit Evidence shall show that knowledge has been acquired for safe working practices of: T1 Relevant Environmental, Occupational Health and Safety legislation and regulations T2 Enterprise procedures T3 Plant drawings and manufacturers manuals T4 Introduction to and typical arrangements of power production plant T5 Relevant plant and equipment, its location and operating parameters T6 Electric motor types and characteristics T7 Pump and compressor types and characteristics T8 Valve, damper and actuator types and characteristics T9 Switchgear types and characteristics T10 Electrical protection types and characteristics T11 Relevant state and territory regulations T12 Gas turbine principle of operation T13 Air intake, types and characteristics T14 Air inlet cooling and heating systems, types and characteristics T15 Exhaust, types and characteristics T16 Lubrication systems, types and characteristics T17 Control oil systems, types and characteristics T18 Water wash systems, types and characteristics T19 Cooling systems, types and characteristics T20 Water/steam injection systems, types and characteristics T21 Combustion system, types and characteristics T22 Generator, types and characteristics T23 Generator excitation system, types and characteristics T24 Electrical fundamentals T25 Plant status T26 Enterprise recording procedures T27 Control and data acquisition systems T28 Computers and software T29 supervisory, alarm, protection equipment T30 Fire protection control system, types and characteristics KS02-PO336B A gas turbine unit Specific skills needed to achieve the Performance Criteria: T1 Interpret plant drawings and manufacturers manuals T2 Apply relevant state and territory regulations T3 Apply enterprise recording procedures T4 Identify plant status T5 Prepare plant/equipment for operation T6 Organise resources T7 Operate gas turbine plant and equipment T8 Apply diagnostic and testing techniques T9 Identify and respond to abnormal plant operating conditions T10 Plan and prioritise work T11 Use relevant hand tools T12 Communicate effectively T13 Apply data analysis techniques and tools |