Elements and Performance Criteria
- Source irrigation system requirements
- Location of pump is determined following site inspection
- Pump base requirements are identified from drawings and specifications using relevant information
- Required materials and equipment are identified, ordered and collected in accordance with workplace procedures
- Materials and equipment are checked for compliance with relevant Australian standards, docket and order form, and for acceptable condition
- Sustainability principles and concepts are applied to work preparation and application
- Plan and sequence installation tasks from instructions
- Drawings and specifications are obtained
- OHS requirements associated with installing water pump sets, and workplace environmental requirements, are adhered to throughout the work
- Workplace instructions are identified and adhered to
- Tasks are planned and sequenced in conjunction with others involved in or affected by the work and statutory and regulatory authority requirements
- Work area is prepared to support efficient installation of water pump sets
- Select and check tools and equipment for serviceability
- Install and commission pumping and flow control components
- Pump base is set out to comply with drawings and specifications
- Pump base is constructed in accordance with drawings and specifications
- Pump and pump controls are installed in accordance with relevant Australian standards, drawings, specifications and manufacturer instructions
- Suction and discharge lines andflow control devices are connected
- Delivery and distribution components connected to pump comply with relevant specifications and manufacturer instructions
- Pressure testing of pumping system is conducted in accordance with specifications
- Pump is tested in accordance with specifications and test data is recorded in required format
- Clean up after installation
- Work area is cleared and materials disposed of, reused or recycled according to legislation, regulations, codes of practice and job specification
- Tools and equipment are cleaned, checked, maintained and stored in accordance with manufacturer recommendations and workplace procedures
- Documentation is completed in accordance with workplace requirements
- Review, record and report activities.