Elements and Performance Criteria
- Prepare for work
- Work instructions are used to determine job requirements, including method, process and equipment
- Job specifications are read and interpreted
- OHS requirements, including personal safety needs, are observed throughout the work
- Equipment and tooling are identified and checked for safe and effective operation
- Procedures are determined to minimise task time
- Service batteries
- Information is accessed from manufacturer/component supplier specifications and correctly interpreted
- Material, components, tooling and equipment to complete work are identified, selected and prepared in accordance with site procedures
- Electrolyte levels are checked and topped up in accordance with site procedures
- Batteries and terminals are cleaned in accordance with site procedures
- Batteries are removed and replaced safely according to site procedures
- Charge batteries
- Information for charging is accessed from manufacturer/ component supplier specifications and correctly interpreted
- Components, tooling and equipment to complete work are identified, selected and prepared in accordance with site procedures
- Electrolyte levels are checked and topped up in accordance with site procedures
- Batteries are charged in accordance with site procedures and component manufacturer/component supplier recommendations
- Test batteries
- Information for battery testing is accessed from product and vehicle manufacturer/component supplier specifications and correctly interpreted
- Components, tooling and equipment are identified, selected and prepared in accordance with site procedures
- Battery tests are performed and results analysed in accordance with site procedures and product/manufacturer/component supplier specifications
- Battery testing procedures are carried out in accordance with legislation, industry and enterprise policies/ procedures guidelines
- Jump-start vehicle
- Information is accessed from manufacturer/component supplier specifications and correctly interpreted
- Leads are connected/disconnected in correct sequence and polarity
- All work is carried out without causing damage to component or system
- Workplace documents are completed in accordance with enterprise procedures
- Clean up work area and maintain equipment
- Material that can be reused is collected and stored
- Waste and scrap is removed following workplace procedure
- Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures
- Unserviceable equipment is tagged and faults identified in accordance with workplace requirements
- Operator maintenance is completed in accordance with manufacturer/component supplier specifications and site procedures
- Tooling and equipment is maintained in accordance with workplace procedures