Elements and Performance Criteria
- Prepare for work
- Work instructions are used to determine job requirements, including method and material type
- Job specifications are read and interpreted
- OH&S requirements, including personal protection needs, are observed throughout the work
- Materials are selected and inspected for quality
- Hand, power tooling and safety equipment are identified and checked for safe use
- Procedures are determined to minimise waste material
- Procedures are identified for maximising energy efficiency while completing job
- Service air compressor
- Information is accessed and interpreted from manufacturer/component supplier specifications
- Service is carried out using approved methods and equipment, according to specifications relative to the plant/system
- Service operations are completed within established industry guidelines
- Air compressor is serviced without causing damage to component or system
- Workplace documentation is completed and dealt with relevant to service outcomes
- Servicing activities are carried out according to industry regulations/guidelines, OH&S requirements, legislation and enterprise procedures/policies
- Service pressure regulators and air lines
- Information is accessed and interpreted from manufacturer/component supplier specifications
- Service is carried out using approved methods and equipment, according to specifications relative to the plant/system
- Service operations are completed within established industry guidelines
- Pressure regulators and air lines are serviced without causing damage to component or system
- Servicing activities are carried out according to industry regulations/guidelines, OH&S requirements, legislation and enterprise procedures/policies
- Clean up work area and maintain equipment
- Material that can be reused is collected and stored
- Waste and scrap is removed following workplace procedure
- Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures
- Unserviceable equipment is tagged and faults identified in accordance with workplace procedures
- Operator maintenance is completed in accordance with manufacturer/component supplier specifications and worksite procedures
- Tooling is maintained in accordance with workplace procedures