Elements and Performance Criteria
- Prepare for work
- Work instructions are used to determine job requirements, including job sheets, test procedures and manufacturer/ component supplier specifications.
- Job specifications are read and interpreted.
- Occupational health and safety (OHS) requirements, including personal protection needs, are observed throughout the work.
- Units/components to be disassemble and tested are identified.
- Hand, power tooling and safety equipment are identified and checked for safe use.
- Procedures are determined to minimise waste material/ components.
- Procedures are identified for maximising energy efficiency while completing the job.
- Disassemble units/ components
- Component to be disassembled is identified from customer or enterprise information.
- Methods for disassembling components are determined according to enterprise policies and procedures and manuals/specifications.
- Components are disassembled and tolerances/wear checked against manufacturer/component supplier specifications.
- Decision to retain/replace/repair/adjust/service component is determined according to enterprise policies and procedures.
- Clean and test units/ components
- Clean up work area and maintain equipment
- Material that can be reused is collected and stored.
- Waste and scrap is removed following workplace procedures.
- Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures.
- Unserviceable equipment is tagged and faults identified in accordance with workplace procedures.
- Operator maintenance is completed in accordance with manufacturer/component supplier specifications and worksite procedures.
- Tooling is maintained in accordance with workplace procedures.