Elements and Performance Criteria
- Prepare for work
- Work instructions are used to determine the job requirements, including method, materials and equipment.
- Job specifications are read and interpreted.
- OH&S requirements, including personal protection needs are observed throughout the work.
- Material for removal and replacement is selected.
- Equipment and tooling are identified and checked for safe and effective operation.
- Procedures are determined to minimise waste material.
- Procedures are identified for maximising energy efficiency while completing the job.
- Deactivate and remove supplementary restraint systems
- Information is accessed and interpreted from manufacturer/ component supplier specifications.
- The supplementary restraint system is deactivated and removed using approved methods, tooling and equipment.
- The system is deactivated and removed without causing damage to any component or system.
- Deactivation and removal activities are carried out according to industry regulations/guidelines, OH&S legislation, and enterprise procedures/policies.
- System/components are tagged and stored to manufacturer/ component supplier and workplace standards.
- Replace and recommission supplementary restraint systems
- Information is accessed and interpreted from manufacturer/ component supplier specifications.
- Supplementary restraint systems are replaced and recommissioned using approved methods, tooling and equipment.
- Replacement and recommissioning are completed without causing damage to any component or system.
- Replacement and recommissioning activities are carried out according to industry regulations/guidelines, OH&S legislation, and enterprise procedures/policies.
- Workplace/equipment documentation is completed and processed to enterprise/manufacturer/component supplier requirements.
- Clean up work area and maintain equipment
- Material that can be reused is collected and stored.
- Waste and scrap is removed following workplace and environmental procedure.
- Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures.
- Unserviceable equipment is tagged and faults identified in accordance with workplace requirements.
- Operator maintenance is completed in accordance with manufacturer/component supplier specifications and worksite procedures.
- Tooling is maintained in accordance with workplace procedures.