Elements and Performance Criteria
- Prepare for work
- Work instructions are used to determine job requirements, including method, material and equipment.
- Job specifications are read and interpreted.
- WHS requirements, including dust and fume collection, breathing apparatus, eye and ear personal protection needs are observed throughout the work.
- Materials for use are selected appropriate to the application.
- Equipment and tooling are identified and checked for safe and effective operation.
- Procedures are determined to minimise waste material.
- Procedures are identified for maximising energy efficiency while completing the job.
- Remove butyl sealed windscreen
- Information is accessed and interpreted from manufacturer/ component supplier specifications.
- Removal is carried out in accordance with vehicle manufacturer/component supplier specifications and tolerances.
- Removal is completed without causing damage to component or system.
- Workplace documentation is completed and dealt with.
- Removal activities are carried out according to industry regulations/guidelines, WHS requirements, legislation and enterprise procedures/policies.
- Install butyl sealed windscreen
- Information is accessed and interpreted from manufacturer/ component supplier specifications.
- Installation is carried out in accordance with vehicle manufacturer/component supplier specifications and tolerances.
- Installation is completed without causing damage to component or system.
- Installation is tested in accordance with manufacturer/ component supplier and workplace requirements.
- Workplace documentation is completed and dealt with.
- Installation activities are carried out according to industry regulations/guidelines, WHS requirements, legislation and enterprise procedures/policies.
- Clean up work area and maintain equipment
- Material that can be reused is collected and stored.
- Waste and scrap are removed following workplace and environmental procedures.
- Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures.
- Unserviceable equipment is tagged and faults identified in accordance with workplace requirements.
- Operator maintenance is completed in accordance with manufacturer/component supplier specifications and worksite procedures.
- Tooling is maintained in accordance with workplace procedures.