Elements and Performance Criteria
- Prepare for work
- Work instructions are used to determine job requirements including method and material type.
- Job specifications are read and interpreted.
- WHS requirements, including personal protection needs, are observed throughout the work.
- Materials are selected and inspected for quality.
- Hand and power tooling, and safety equipment are identified and checked for correct operation.
- Procedures are determined to minimise waste material.
- Procedures are identified for maximising energy efficiency while completing the job.
- Determine paint fault cause and rectification requirements for multi-layer/pearl (two component system) paint materials
- Cause of paint fault is determined from available information to provide background for report/repair.
- Visual inspection of vehicle is undertaken to determine the extent of damage and areas requiring repair/rework.
- Damage to paintwork is assessed from visual comparison with undamaged paintwork.
- Determinations are carried out according to industry regulations/guidelines, WHS legislation, statutory legislation and enterprise procedures/policies.
- Paint faults cause and rectification requirements are determined without causing undue damage to any component or system.
- Rectify and touch up paint faults of multi-layer/pearl (two component system) paint materials
- Materials required to restore paintwork to "as new" condition are determined from industry and manufacturer/ component supplier.
- Damaged paintwork is rectified to blend with existing paintwork on vehicle.
- Rectification operations are carried out according to industry regulations/guidelines, WHS legislation, statutory legislation and enterprise procedures/policies.
- Paint faults are rectified without causing damage to any component or system.
- Clean up work area and maintain equipment
- Material that can be reused is collected and stored.
- Waste and scrap is removed following workplace procedure.
- Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures.
- Unserviceable equipment is tagged and faults identified in accordance with workplace procedures.
- Operator maintenance is completed in accordance with manufacturer/component supplier specifications and site procedures.
- Tooling is maintained in accordance with workplace procedures.