Elements and Performance Criteria
- Plan and prepare.
- Work instructions and operational details are obtained using relevant information, confirmed and applied for planning and preparation purposes.
- Safety (OHS) requirements are followed in accordance with safety plans and policies.
- Signage and barricade requirements are identified and implemented.
- Tools and equipment selected to carry out tasks are consistent with the requirements of the job, checked for serviceability and any faults are rectified or reported prior to commencement.
- Material quantity requirements are calculated in accordance with plans and specifications and quality requirements.
- Materials appropriate to the work application are identified, obtained, prepared, safely handled and located ready for use.
- Environmental requirements are identified for the project in accordance with environmental plans and regulatory obligations and applied.
- Determine work requirements.
- Work area is inspected to determine work requirements.
- Level of finish as specified in the contract or job order is noted and any mismatches between quality of fixing and finishing are recorded and reported or rectified as appropriate.
- Personal protective equipment suitable for the task is selected based on manufacturers' recommended and employer-approved specification.
- Sand joins.
- Inspect work and clean up work area.
- Clean up.
- Work area is cleared and materials are disposed of, reused or recycled in accordance with legislation, regulations, codes of practice and job specification.
- Sanding dust is cleaned up and contained for disposal in accordance with approved workplace procedures, with any hazardous material identified for separate handling.
- Non-toxic materials are removed using correct procedures.
- Dust suppression procedures are used to minimise health risk to work personnel and others.
- Tools and equipment are cleaned, checked, maintained and stored in accordance with manufacturer recommendations and standard work practices.