Elements and Performance Criteria
- Plan and prepare.
- Work instructions, including plans, specifications, quality requirements and operational details are obtained for relevant information, confirmed and applied for the scope of work performed.
- Safety (OHS) requirements are followed in accordance with safety plans and policies.
- Signage and barricade requirements are identified and implemented.
- Plant, tools and equipment selected to carry out tasks that are consistent with the requirements of the job, checked for serviceability and any faults are rectified or reported prior to commencement.
- Materials quantity requirements are calculated in accordance with plans, specifications and quality requirements.
- Materials appropriate to the work application are identified, obtained, prepared, safely handled and located ready for use.
- Environmental requirements are identified for the project in accordance with environmental plans and statutory and legislative authority obligations and applied.
- Prepare roof face.
- Fall arrest system is installed to roof perimeter following regulations and workplace requirements.
- Elevator is assembled and operated in accordance with manufacturer instructions and workplace procedures.
- Roof surface and structure are checked for stability and safe access to roof for tile installation.
- Roof surface is set out and sarked to manufacturer recommendations for specified tile and job specifications.
- Cut and fix battens.
- Install tiles.
- Tiles are loaded onto roof, supported and evenly distributed.
- Roof tiles are spread, cut, secured and installed to manufacturer specifications.
- Roof tiles are bedded using correct mortar mix, maintaining alignment.
- Roof tiles are pointed with mortar to a flush, smooth finish in accordance with job specifications and are installed to manufacturer specifications.
- Clean up.
- Roof, guttering and downpipes are cleared free of waste and surplus material.
- Work area is cleared and materials disposed of, reused or recycled in accordance with legislation, regulations, codes of practice and job specification.
- Plant, tools and equipment are cleaned, checked, maintained and stored in accordance with manufacturer recommendations and standard work practices.