This section specifies work environments and conditions that may affect performance. Essential operating conditions that may be present (depending on the work situation, needs of the candidate, accessibility of the item, and local industry and regional contexts) are included. Bold italicised wording, if used in the performance criteria, is detailed below. |
Job requirements must include: | job specifications for setting out, fabricating and assembling shopfront components, including:material quantity requirementsdetails of the components to be produced and the production methods to be usedquality requirements for the completed worktimeframe for completionJSA or SWMS for tasksworkplace procedures incorporating requirements of relevant legislation, regulations, codes and Australian standardsworkplace and work site environmental and sustainability requirements, including:clean-up managementdust and noise managementwaste management. |
Levelling techniques must include using: | laser levelspirit level. |
Health and safety requirements must include: | selection, correct fitting, and use of personal protective equipment (PPE) prescribed under legislation, regulations and workplace policies and practicesemergency procedures, including:evacuationfirst aidlocation and use of firefighting equipmenthazard identification and risk control proceduressafe operating procedures, including:safety data sheets (SDS)manufacturer specificationsmanual handling techniquesrequirements for:lightingwork site visitors and the publicworking in proximity to othersselection and use of tools and equipmentreporting of health and safety issues, hazards, accidents and incidentsduty of careidentifying, safe handling, securing and labelling of hazardous materials. |
Tools and equipment must include ten or more of the following: | air compressor and hoseschalk lineschisels, including cold chiselsclampsgrindershammershand sawslaser levelsmeasuring tapes and rulespower drillspower leadspower planersrouterssanderssash crampssaw stoolsscrewdriversset spannerssquares. |
Materials must include: | aluminiumglasstimberspecial finishes. |
Setting out of components must include one or more of the following: | computer generated set-outmanual set-outeither full size or rod. |
Static machines must include one or more of the following: | bench grindersthicknessers/jointerspanel saws. |
Fixings and fasteners must include three or more of the following: | bolts and nutsscrewsgluesmetal bracketsself-tapping screwssiliconesspeciality adhesives and tapes. |
Fittings must include one or more of the following: | closershandlesstops. |