Elements and Performance Criteria
- Prepare for work.
- Drawings and specifications are obtained.
- Safety (OHS) requirements associated with installing water pump sets, and workplace environmental requirements, are adhered to throughout the work.
- Quality assurance requirements are identified and adhered to in accordance with workplace requirements.
- Tasks are planned and sequenced in conjunction with others involved in or affected by the work and statutory and regulatory authority requirements.
- Tools and equipment for installing water pump sets, including personal protective equipment, are selected and checked for serviceability.
- Work area is prepared to support efficient installation of water pump sets.
- Identify installation requirements.
- Location of pump is determined following site inspection.
- Pump base requirements are identified from drawings and specifications using relevant information.
- Required materials and equipment are identified, ordered and collected in accordance with workplace procedures.
- Materials and equipment are checked for compliance with relevant Australian standards, docket and order form, and for acceptable condition.
- Sustainability principles and concepts are applied to work preparation and application.
- Install water pump sets.
- Pump base is set out to comply with drawings and specifications.
- Pump base is constructed in accordance with drawings and specifications.
- Pump and pump controls are installed in accordance with relevant Australian standards, drawings, specifications and manufacturer instructions.
- Fuel tank fitting, alignment of shafts and couplings, and the use of mechanical joints comply with relevant specifications and manufacturer instructions.
- Pressure testing of piping system is conducted in accordance with specifications.
- Pump set is tested in accordance with specifications and test data is recorded in required format.
- Clean up.
- Work area is cleared and materials disposed of, reused or recycled according to legislation, regulations, codes of practice and job specification.
- Tools and equipment are cleaned, checked, maintained and stored in accordance with manufacturer recommendations and workplace procedures.
- Documentation is completed in accordance with workplace requirements.