Elements and Performance Criteria
- Prepare for work
- Workplace health and safety requirements, including personal protection needs, are observed throughout the work
- Tools, machines and materials are selected and checked prior to use to ensure that they are appropriate for the work, serviceable and in a safe condition
- Furniture design, tolerances, process, materials and quantities are determined from work instructions
- Work sequence is planned
- Procedures are determined for checking quality at each stage of the process
- Suitable work area is selected for the task
- Preparatory drawings/set-outs for tasks are completed where required
- Complete bending and forming process
- Tools, machines and equipment are used in accordance with safety requirements and manufacturers' specifications
- Materials are visually inspected for flaws and faults
- Cane is machine sanded to remove exterior blemishes, flaws or faults
- Cane is prepared by straightening where required and marked for bending
- Cane is heated in ovens in accordance with design/pattern bending requirements
- Cane is bent in accordance with design/pattern requirements
- Product is checked against plans at identified checkpoints to ensure compliance with specifications
- Non-conformity with the required quality standards is rectified
- Finalise operation
- Faulty and/or defective equipment is tagged and reported in accordance with workplace practices
- Work area is cleaned, hand and/or power tools and equipment are cleaned, maintained and stored in accordance with workplace procedures
- Off-cuts and unused materials are collected and stored for reuse or disposed of following workplace procedures
- Waste and scrap materials are dealt with following workplace procedures