Elements and Performance Criteria
- Prepare to inspect and test an electrical installation
- WHS/OHS risk control measures and procedures in preparation for the work are followed
- WHS/OHS hazards not previously identified are noted, risks assessed and risk control measures implemented
- Installation documentation and relevant industry standard are reviewed and applied
- Appropriate person/s is consulted to ensure the work is coordinated effectively with others
- Tools, equipment and testing devices needed to verify compliance are obtained in accordance with workplace procedures and checked for operation and safety
- Preparatory work is checked to ensure no damage has occurred in accordance with workplace procedures
- Visually inspect the installation
- Need to inspect, test and measure live work is determined in accordance with WHS/OHS requirements and workplace procedures
- Circuits/machines/plant are checked and isolated in accordance with WHS/OHS requirements and workplace procedures
- Installed wiring is checked for suitability for the environments and protected from damage and overheating
- Cable conductor sizes acquired are inspected to meet current-carrying capacity requirements, voltage-drop and fault-loop impedance limitations in accordance with relevant industry standards
- Inspection protection methods and devices are validated to meet coordination requirements for overload and short circuit protection in accordance with relevant industry standards
- Switchgear and control gear are inspected, validated and appropriately rated to meet functional requirements in accordance with relevant industry standards
- Electrical equipment is checked for compliance with safety requirements in accordance with relevant industry standards
- Earthing system components are checked, located and conductors correctly sized in accordance with relevant industry standards
- Markings on switchboards are checked for accuracy and clarity in accordance with relevant industry standards
- Conduct safety testing
- Need to test and measure live electrical work is conducted in accordance with WHS/OHS requirements and workplace procedures
- Mandatory tests are conducted to verify earthing conductor resistance is sufficiently low; insulation resistance is sufficiently high; polarities are correct; circuit connections are correct; and tests are in accordance with relevant industry standards
- Inspection and testing are conducted to verify fault-loop impedance is sufficiently low and residual current device (RCD) operates as intended in accordance with job requirements and relevant industry standards
- Report inspection and test findings
- Worksite is cleaned and made safe in accordance with workplace procedures
- Non-compliance defects are identified and reported in accordance with workplace procedures
- Recommendations for rectifying defects are made in accordance with workplace procedures
- Mandatory documentation is completed in accordance with workplace procedures