Subjects
Total number of units = 14
5 core plus
9 elective units
The elective units consist of:
up to 9 units may be selected from Group A Copper cabling, or Group B Fibre cabling or Group C HFC cabling
up to 6 units may be selected from Group D General or from elsewhere in this Training Package
2 units of competency may be selected from any currently endorsed Training Package or accredited course at AQF Level 3 or 4.
Elective units must be relevant to the work environment and the qualification, and contribute to a valid, industry-supported vocational outcome.
Units selected from other Training Packages or accredited courses must not duplicate units selected from, or available within, the ICT Information and Communications Technology Training Package.
Refer to the Specialisations information below, and to the Companion Volume Implementation Guide, for advice about choosing electives to support specialisations.
Core units
BSBSUS401 Implement and monitor environmentally sustainable work practices
ICTTEN201 Use electrical skills in telecommunications work
ICTTEN202 Use hand and power tools
ICTWHS204 Follow work health and safety and environmental policy and procedures
ICTWOR305 Supervise worksite activities
Elective units
Group A Copper cabling
ICTCBL215 Joint metallic conductor cable in access network
ICTCBL313 Modify and cutover cable
ICTCBL317 Cut over metallic conductor cable in the access network
ICTCBL318 Install and cut over metallic conductor cable to access network cabinet
ICTCBL319 Rearrange large size copper cable
ICTCBL320 Jumper metallic conductor cable in the access network
ICTTEN303 Locate, identify and rectify recurrent network faults
Group B Fibre cabling
ICTBWN301 Perform tests on optical communication system and components
ICTBWN302 Install optical fibre splitters in fibre distribution hubs
ICTCBL208 Splice and terminate optical fibre cable for carriers and service providers
ICTCBL302 Install and terminate optical fibre cable on customer premises
ICTCBL316 Install ribbon fibre cable in the FTTX distribution network
ICTTEN409 Commission an electronic system
ICTTEN416 Install, configure and test an internet protocol network
Group C HFC cabling
ICTRFN406 Maintain hybrid fibre coaxial broadband cable network
ICTCBL303 Install and terminate coaxial cable
ICTCBL310 Install aerial cable
ICTCBL309 Construct aerial cable supports
Group D General
CPCCOHS1001A Work safely in the construction industry
CPCCCM2007B * Use explosive power tools
CPCCDE3014A * Remove non-friable asbestos
CPCPCM2043A Carry out WHS requirements
CPCPCM2055A * Work safely on roofs
ICTBWN304 * Work safely with live fibre to test and commission a fibre to the x installation
ICTBWN305 Use optical and radio frequency measuring instruments
ICTBWN303 Install lead-in module and cable for fibre to the premises
ICTCBL307 Install underground enclosures and conduit
ICTCBL308 Install underground cable
ICTCBL236 * Install, maintain and modify customer premises communications cabling: ACMA Restricted Rule
ICTCBL237 * Install maintain and modify customer premises communications cabling: ACMA Open Rule
ICTTEN302 Install telecommunications network equipment
ICTTEN310 Remove and replace electronic circuit boards in carrier equipment
ICTTEN311 Inspect, clean and handle optical fibre cable and connectors
HLTAID001 Provide cardiopulmonary resuscitation
ICTTEN207 Install and test internet protocol devices in convergence networks
ICTWHS203 Work safely near power infrastructure
TLID2010A Operate a forklift
ICTWHS201 Provide telecommunications services safely on roofs
RIIWHS204D Work safely at heights
Specialisations
The use of specialist streams is appropriate for this qualification in accordance with the AQF, Standards for Training Packages and the packaging rules. Where a specialist stream is achieved, testamurs must show the appropriate specialisation in brackets. Refer to the Companion Volume Implementation Guide for further advice about specialisations.
Minimum elective units required for the specific specialisations are described below.
Copper Cable Jointer
The following 7 electives must be selected:
CPCCOHS1001A Work safely in the construction industry
ICTCBL215 Joint metallic conductor cable in access network
ICTCBL317 Cut over metallic conductor cable in the access network
ICTCBL318 Install and cut over metallic conductor cable to access network cabinet
ICTCBL319 Rearrange large size copper cable
ICTTEN302 Install telecommunications network equipment
ICTTEN303 Locate, identify and rectify recurrent network faults.
Technician Fibre
The following 8 electives must be selected:
CPCCOHS1001A Work safely in the construction industry
ICTBWN304 * Work safely with live fibre to test and commission a fibre to the x installation
ICTCBL302 Install and terminate optical fibre cable on customer premises
ICTTEN302 Install telecommunications network equipment
ICTTEN310 Remove and replace electronic circuit boards in carrier equipment
ICTTEN311 Inspect, clean and handle optical fibre cable and connectors
ICTTEN409 Commission an electronic system
ICTTEN416 Install, configure and test an internet protocol network.
Fibre Splicer
The following 7 electives must be selected:
CPCCOHS1001A Work safely in the construction industry
ICTBWN302 Install optical fibre splitters in fibre distribution hubs
ICTBWN304 * Work safely with live fibre to test and commission a fibre to the x installation
ICTBWN305 Use optical and radio frequency measuring instruments
ICTCBL208 Splice and terminate optical fibre cable for carriers and service providers
ICTCBL316 Install ribbon fibre cable in the FTTX distribution network
ICTTEN311 Inspect, clean and handle optical fibre cable and connectors.
Technician HFC
The following 6 electives must be selected:
CPCCOHS1001A Work safely in the construction industry
ICTBWN305 Use optical and radio frequency measuring instruments
ICTCBL303 Install and terminate coaxial cable
ICTRFN406 Maintain hybrid fibre coaxial broadband cable network
ICTTEN302 Install telecommunications network equipment
ICTCBL310 Install aerial cable
Plus:
CPCPCM2055A * Work safely on roofs and CPCPCM2043A Carry out WHS requirements
or
ICTWHS201 Provide telecommunications services safely on roofs
or
RIIWHS204D Work safely at heights.
*Note the following prerequisite unit requirements:
Unit in this qualification | Prerequisite unit |
|
|
|
|
|
|
|
|
|
|
|
|