UEE42211 - Certificate IV in Instrumentation and Control
Certificate IV in Instrumentation and Control
Scope
This qualification provides competencies to select, install, set up, test, fault find, repair, maintain and commission systems and devices for measurement and recording of physical/chemical phenomenon and related process control systems.
Subjects
Completion requirements
The requirements for granting this qualification will be met when competency is demonstrated and achieved for:
All the Core competency standard units, defined in the Core Competency Standard Units table below and
A combination of Elective competency standard units to achieve a total weighting of 200 points in accordance with the Elective Competency Standard Units table below.
Note: UEENEEI112A - Those holding an Certificate III in Instrumentation and Control trade qualification or equivalent" meet the requirements of this unit and its pre-requisite requirements.
Disconnect /reconnect control devices connected to low voltage installation wiring
60
Total points in core
1080
Elective Competency Standard Units
Complete Elective units to achieve a total of weighting of 200 points from the following groups:
Group
Minimum points
Maximum points
A
Imported and Common Elective Units
Imported units from other training packages and/or state accredited courses can be added to this group, but they must be selected from qualifications where the unit is first packaged at AQF level 4. If units have not being assigned a weighting by the relevant EE-Oz Industry Technical Advisory Committee, their weighting will be 10 points.
0
60
B
Qualification Elective Units
0
100
C
Qualification Elective Units
You may select all your elective units from this Group
100
200
Group A Imported and Common Elective Units
You may complete units to a maximum weighting of 60
Imported units from other training packages and/or state accredited courses can be added to this group, but they must be selected from qualifications where the unit is first packaged at AQF level 4. If units have not being assigned a weighting by the relevant EE-Oz Industry Technical Advisory Committee, their weighting will be 10 points.
Note: For further information see Application of the NQC Flexibility Formula, UEE11 Electrotechnology Training Package, Version 1, Volume 1 Qualification Framework
Up to 60 points
Group B Qualification Elective Units
You may complete units to a maximum weighting of 100
Conduct detailed inspection of hazardous areas installations pressurisation
40
Note: 1. Prerequisite pathways shall be identified and met for all elective units selected.
2. In selecting elective units considerations to career planning advice should be given to units that form part of a prerequisite pathway for the progression to achieve particular competencies or qualification at a higher level.