UEE42611 - Certificate IV in Hazardous areas - Electrical
Certificate IV in Hazardous areas - Electrical
Scope
This qualification provides competencies to supervise selection, installation, commissioning maintenance and testing of explosion-protected equipment and systems for control and monitoring of plant and processes. The qualification provides competencies in working with explosion protections techniques with elections in how they apply to coal mining, gas and dust atmospheres. It includes ERAC requirements for an ‘Electrician’s licence’ and competencies to select, install, set up, test, fault find, repair and maintain stand alone renewable energy equipment and systems.
Subjects
Completion requirements
The requirements for granting this qualification will be met when competency is demonstrated and achieved for:
All the Core competency standard units, defined in the Core Competency Standard Units table below and
A combination of Elective competency standard units to achieve a total weighting of 300 points in accordance with the Elective Competency Standard Units table below.
Note: UEENEEG105A - Those holding an Unrestricted Electricians Licence or equivalent issued in an Australian State or Territory meets the requirements of this unit and its pre-requisite requirements.
Report on the integrity of explosion-protected equipment in a hazardous areas
20
Total points in core
980
Elective Competency Standard Units
Complete Elective units to achieve a total of weighting of 300 points from the following groups:
Group
Minimum points
Maximum points
A
Imported and Common Elective Units
Imported units from other training packages and/or state accredited courses can be added to this group, but they must be selected from qualifications where the unit is first packaged at AQF level 4. If units have not being assigned a weighting by the relevant EE-Oz Industry Technical Advisory Committee, their weighting will be 10 points.
0
60
B
Qualification Elective Units
0
80
C
Qualification Elective Units
You may select all your elective units from this Group
220
300
Group A Imported and Common Elective Units
You may complete units to a maximum weighting of 60
Imported units from other training packages and/or state accredited courses can be added to this group, but they must be selected from qualifications where the unit is first packaged at AQF level 4. If units have not being assigned a weighting by the relevant EE-Oz Industry Technical Advisory Committee, their weighting will be 10 points.
Note: For further information see Application of the NQC Flexibility Formula, UEE11 Electrotechnology Training Package, Version 1, Volume 1 Qualification Framework
Up to 60 points
Group B Qualification Elective Units
You may complete units to a maximum weighting of 80
Note: 1. Prerequisite pathways shall be identified and met for all elective units selected.
2. In selecting elective units considerations to career planning advice should be given to units that form part of a prerequisite pathway for the progression to achieve particular competencies or qualification at a higher level.