UEE51010 - Diploma of Instrumentation and Control Engineering
Diploma of Instrumentation and Control Engineering
Scope
This qualification provides competencies to install, set up, test, develop, select, commission, maintain and diagnose faults/malfunctions of equipment and systems for the measurement, recording, monitoring and control of physical/chemical phenomenon and related process control systems.
Subjects
Completion requirements
The requirements for awarding this qualification are that the following are successfully achieved:
All of the Core competency standard units;
The required number of Stream Core competency standard units;
The required number of Elective competency standard units as prescribed in the respective Schedule; and
All the required pre-requisite competency standard units have been met as required.
Note: UEENEEI012B - Those holding an 'Certificate III in Instrumentation and Control trade qualification or equivalent" meet the requirements of this unit and its pre-requisite requirements.
Implement&monitor, policies&procedures for environmentally sustainable electrotech work practice
Elective Competency Standard Units
In accordance with Schedules 3, 4 and 5 which form an integral part of this qualification, achieve a Unit Strand Total of at least 24 of which at least 14 shall be selected from Schedule 5, and not more than 6 from Schedule 4 and not more than 4 from Schedule 3 as specified.
Note: 1. Pre-requisite pathways shall be identified and met for all elective units selected.
2. In selecting elective units considerations to career planning advice should be given to units that form part of a pre-requisite pathway for the progression to achieve particular competencies or qualification at a higher level.
3. Registered training organisations shall provide competency development advice in relation to any licensing requirements to practice that apply, or can contribute towards the qualification requirement, prior to establishing the competency development plan.