Completion requirements

The requirements for granting this qualification is the successful completion:

1. All the Core Units (no weighting points attached to Core Units), and

2. Five (5) of seven (7) nominated Stream Core Units (no weighting points attached to Stream Core Units). Unit/s not selected as Stream Core could be used as Electives, and

3. Any combination of Elective Units from Schedules 3, 4 and 5 detailed in the Schedule of Electives within this Qualification Structure where the sum of the weighting value is no less than 600points, with a minimum of 300 weighting points drawn from Schedule 5), or,

4. Imported Units from any other Training Package at a similar AQF level qualification. Imported Units must be approved and valued by the National Generation Training Group for them to contribute to the required 600points, and

5. All Prerequisite requirements (no weighting points) including a relevant trade certificate.

Note:

Schedules 3, 4 and 5 forms an integral part of this qualification

Only units nominated as Core and Stream Core units can be recognised when they appear as Core or Stream Core in another qualification.

No provision exists for the double counting of Core and Steam Core Units as Elective Unit points towards a second qualification.

Once an Elective Unit of Competence has been achieved and the points gained have counted towards a qualification the points cannot be used again to contribute towards any other qualification.

Core Units - All required

UEPOPS203A

Operate and Monitor Communications Systems

UEPOPS337A

Maintain Quality Systems within the Team

UEPOPS401A

Monitor Compliance Occupational Health and Safety Policy and Procedures

UEPOPS417A

Monitor and Implement the Application of Environmental Plans and Procedures

Stream Core - Must have 5 of 7 units

UEPOPS338A

Facilitate Effective Workplace Communications

UEPOPS439A

Plan and Organise Work

UEPMNT401A

Install and Maintain Complex Mechanical Seals

UEPMNT402A

Conduct Complex Levelling and Alignment

UEPMNT403A

Maintain Complex Mechanical Valves

UEPMNT404A

Maintain Complex Mechanical Pumps

UEPMNT421A

Conduct Technical Inspections of Process Plant and Equipment

Elective Units - 600 points from any combination of units from Schedules 3, 4&5 (with a minimum of 300 weighting points drawn from Schedule 5)