UET30812 - Certificate III in ESI - Power Systems - Distribution Cable Jointing
Certificate III in ESI - Power Systems - Distribution Cable Jointing
Scope:
Those gaining this qualification will be able to acquire the skills and knowledge needed for a career in the Electricity Supply Industry. The scope of this qualification covers:
Cable Jointing such as the laying, installation and maintenance of de-energised Low Voltage and High Voltage underground polymeric cables and the installation and maintenance of electrical equipment. Options are available for skills to be obtained for energised cables and or Low Voltage and High Voltage paper insulated cables.
Subjects
Completion requirements
The requirements for granting this qualification will be met when competency is demonstrated and achieved for:
All the Core competency standard units, defined in the Core Competency Standard Units table below and
A combination of Elective competency standard units to achieve a total weighting of 280 points in accordance with the Elective Competency Standard Units table below.
All the required prerequisite competency standard units have been met.
Install and maintain low voltage underground services
40
Total points in core
800
Elective Competency Standard Units
Complete Elective units to achieve a total of weighting of 260 points from the following groups:
Group
Minimum points
Maximum points
A
Imported and Common Elective Units
Imported units from other training packages and/or state accredited courses can be added to this group, but they must be selected from qualifications where the unit is first packaged at AQF level 3. If units have not being assigned a weighting by the relevant EE-Oz Industry Technical Advisory Committee, their weighting will be 10 points.
0
70
B
Qualification Electives
You may select all your elective units from this Group
190
260
Group A Imported and Common Elective Units
You may complete units to a maximum weighting of 70 points
Terminate cables, cords and accessories for low voltage circuits
40
Imported units from other training packages and/or state accredited courses can be added to this group, but they must be selected from qualifications where the unit is first packaged at AQF level 3. If units have not being assigned a weighting by the relevant EE-Oz Industry Technical Advisory Committee, their weighting will be 10 points.
Note: For further information see Application of the NQC Flexibility Formula, Page 10, UET12 Electricity Supply Industry Transmission, Distribution and Rail Sector Training Package, Version 1, Volume 1 Qualification Framework.
Up to 70 Points
Group B - Qualification Electives
Complete units to at least 190 points from this group.
You may select all your elective units from this Group.
Perform power system substation switching operation to a given schedule
50
Note:
1. Prerequisite pathways shall be identified and met for all elective units selected.
2. In selecting elective units considerations to career planning advice should be given to units that form part of a prerequisite pathway for the progression to achieve particular competencies or qualification at a higher level.