The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Plan and prepare
|
|
Activities are carried out according to OHS and organisation requirements Completed |
Evidence:
|
Work instructions, including relevant inspection reports and forms and quality requirements are obtained, confirmed with appropriate personnel and applied Completed |
Evidence:
|
Tools and equipment selected to carry out tasks are consistent with job requirements, checked for serviceability and any faults are rectified or reported prior to commencement Completed |
Evidence:
|
Materials appropriate to the work application are identified, obtained, prepared, safely handled and located ready for use Completed |
Evidence:
|
Assess structural fault/defect
|
|
Vehicle bodies/components are inspected to confirm the extent and nature of the structural fault or defect Completed |
Evidence:
|
Faults or defects found are assessed for remedial action and on-line or off-line solutions Completed |
Evidence:
|
Solution to repair the fault or defect is selected and planned Completed |
Evidence:
|
Prepare for rectification
|
|
Drawings or sketches are produced to plan and organise the rectification process Completed |
Evidence:
|
Plans/drawings for rectification are presented to appropriate personnel for approval Completed |
Evidence:
|
Equipment or tools to complete the rectification are selected Completed |
Evidence:
|
Repair fault/defect
|
|
Faulty welds, connectors or defective areas are cut or ground in preparation for new welding or connectors Completed |
Evidence:
|
Rectification of structural fault or defect is performed with application of new connectors or re-welding Completed |
Evidence:
|
Faulty or defective area is finished to specifications Completed |
Evidence:
|
Documentation is completed outlining nature of problem, work conducted and outcome, in accordance with organisation requirements Completed |
Evidence:
|
Repaired vehicle/components are processed for inspection and returned to the production sequence Completed |
Evidence:
|
Clean up
|
|
Work area is cleared and materials disposed of, reused or recycled in accordance with organisation requirements and cost reduction initiatives Completed |
Evidence:
|
Tools and equipment are cleaned, checked, maintained and stored in accordance with organisation requirements Completed |
Evidence:
|