The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare for work
|
|
Work instructions are used to determine job requirements, including method, material and equipment. Completed |
Evidence:
|
Job specifications are read and interpreted. Completed |
Evidence:
|
Workplace health and safety (WHS) requirements, including personal protection needs are observed throughout the work. Completed |
Evidence:
|
Material for replacement is selected. Completed |
Evidence:
|
Equipment and tooling are identified and checked for safe and effective operation. Completed |
Evidence:
|
Procedures are determined to minimise waste material. Completed |
Evidence:
|
Procedures are identified for maximising energy efficiency while completing the job. Completed |
Evidence:
|
Remove rear vision mirrors
|
|
Mirrors are removed using approved methods, tooling and equipment. Completed |
Evidence:
|
Removal is completed without causing damage to component or system. Completed |
Evidence:
|
Removal activities are carried out according to industry regulations/guidelines, WHS requirements, legislation and enterprise procedures/policies. Completed |
Evidence:
|
Install rear vision mirrors
|
|
Rear vision mirrors are installed using approved methods, material, tooling and equipment. Completed |
Evidence:
|
Installation is completed without causing damage to component or system. Completed |
Evidence:
|
Installation activities are carried out according to industry regulations/guidelines, WHS requirements, legislation and enterprise procedures/policies. Completed |
Evidence:
|
Clean up work area and maintain equipment
|
|
Material that can be reused is collected and stored. Completed |
Evidence:
|
Waste and scrap are removed following workplace and environmental procedures. Completed |
Evidence:
|
Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures. Completed |
Evidence:
|
Unserviceable equipment is tagged and faults identified in accordance with workplace requirements. Completed |
Evidence:
|
Operator maintenance is completed in accordance with manufacturer/component supplier specifications and worksite procedures. Completed |
Evidence:
|
Tooling is maintained in accordance with workplace procedures. Completed |
Evidence:
|