The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare for work
|
|
Work instructions are used to determine the job requirements, including method, materials and equipment. Completed |
Evidence:
|
Job specifications are read and interpreted. Completed |
Evidence:
|
WHS requirements, including dust and fume collection, breathing apparatus, eye and ear personal protection needs are observed throughout the work. Completed |
Evidence:
|
Material for repair is selected. Completed |
Evidence:
|
Equipment and tooling are identified and checked for safe and effective operation. Completed |
Evidence:
|
Procedures are determined to minimise waste material. Completed |
Evidence:
|
Procedures are identified for maximising energy efficiency while completing the job. Completed |
Evidence:
|
Perform vehicle measuring
|
|
Measurement of the vehicle is completed without causing damage to any component or system. Completed |
Evidence:
|
Equipment selected for vehicle measuring is to vehicle manufacturer/component supplier specifications. Completed |
Evidence:
|
Equipment used for vehicle measuring is prepared and adjusted in accordance with equipment manufacturer/ component supplier specification. Completed |
Evidence:
|
Vehicle is prepared and, installed/located on the equipment in accordance with equipment manufacturer/component supplier instructions. Completed |
Evidence:
|
Nature and extent of misalignment is determined using approved measuring methods. Completed |
Evidence:
|
Results of measurements of vehicle alignment are documented accurately and completely. Completed |
Evidence:
|
Measuring activities are carried out according to industry regulations/guidelines, WHS legislation, and enterprise procedures/policies. Completed |
Evidence:
|
Rectify body and underframe misalignment
|
|
Equipment selected for rectification of alignment is to vehicle manufacturer/component supplier specification. Completed |
Evidence:
|
Equipment used for rectification of alignment is prepared and adjusted in accordance with equipment manufacturer/ component supplier specification. Completed |
Evidence:
|
Vehicle to be aligned is prepared and, installed/located on the alignment equipment in accordance with equipment manufacturer/component supplier instructions. Completed |
Evidence:
|
Hydraulic repair equipment is prepared and attached using equipment manufacturer/component supplier approved methods. Completed |
Evidence:
|
Hydraulic repair equipment is operated using approved methods and techniques. Completed |
Evidence:
|
Alignment of item is reinstated to manufacturer/ component supplier specification and tolerances. Completed |
Evidence:
|
Rectifying of body and underframe misalignment is completed without causing damage to any component or system. Completed |
Evidence:
|
Reinstatement activities are carried out according to industry regulations/guidelines, WHS legislation, and enterprise procedures/policies. Completed |
Evidence:
|
Clean up work area and maintain equipment
|
|
Material that can be reused is collected and stored. Completed |
Evidence:
|
Waste and scrap is removed following workplace and environmental procedures. Completed |
Evidence:
|
Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures. Completed |
Evidence:
|
Unserviceable equipment is tagged and faults identified in accordance with workplace requirements. Completed |
Evidence:
|
Operator maintenance is completed in accordance with manufacturer/component supplier specifications and worksite procedures. Completed |
Evidence:
|
Tooling is maintained in accordance with workplace procedures. Completed |
Evidence:
|