The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare for work
|
|
Workplace instructions and communications are used to determine job requirements, including material type, colour, quality and quantity Completed |
Evidence:
|
Workplace health and safety (WHS) requirements, including personal protective equipment (PPE) needs, are observed throughout the work Completed |
Evidence:
|
Refinishing materials are selected and inspected for quality Completed |
Evidence:
|
Refinishing tools, equipment and PPE are identified and checked for correct operation Completed |
Evidence:
|
Refinishing methods are determined to minimise waste, and maximise energy efficiency while completing the job Completed |
Evidence:
|
Workplace emergency procedures are identified and followed when required Completed |
Evidence:
|
Mix water-based paint colours
|
|
Materials are mixed using the appropriate method Completed |
Evidence:
|
Mixing activities are carried out according to environmental requirements; industry, statutory and regulatory authorities’ guidelines; WHS legislation; and workplace safe operating policies and procedures Completed |
Evidence:
|
Water-based paint colours are mixed without causing damage to components or systems Completed |
Evidence:
|
Apply water-based refinishing materials by spray-gun
|
|
Requirements for environment for applying refinishing materials are identified and observed Completed |
Evidence:
|
Refinishing materials are applied using recommended methods and intervals, in line with information from paint supplier and without causing damage to components or systems Completed |
Evidence:
|
Refinishing materials are dried using approved methods and equipment Completed |
Evidence:
|
Paint surface faults are removed using compounds, polishes and glazes Completed |
Evidence:
|
Finish is produced that meets specifications Completed |
Evidence:
|
Surface refinishing is completed within approved time frames Completed |
Evidence:
|
Identify and rectify paint faults
|
|
Paint faults are identified according to industry and workplace procedures Completed |
Evidence:
|
Paint fault causes are determined according to industry and workplace procedures Completed |
Evidence:
|
Paint surface faults are removed using compounds, polishes and glazes, and rectification procedures that suit fault and type of finish Completed |
Evidence:
|
Rectify and touch up paint faults
|
|
Materials to restore paintwork to as new condition are determined from industry and supplier standards Completed |
Evidence:
|
Damaged paintwork is rectified to blend with existing paintwork quality on vehicles Completed |
Evidence:
|
Rectification operations are carried out according to industry regulations and guidelines, WHS legislation and workplace policies and procedures Completed |
Evidence:
|
Paint faults are rectified without causing damage to components or systems Completed |
Evidence:
|
Clean up work area and maintain equipment
|
|
Material that can be reused is collected and stored according to workplace sustainability practices Completed |
Evidence:
|
Waste material is removed and disposed of or stored according to statutory and workplace procedures Completed |
Evidence:
|
Spray equipment is cleaned as specified by manufacturer, component supplier and workplace policies and procedures Completed |
Evidence:
|
Work area is cleaned and inspected for serviceable condition according to workplace procedures Completed |
Evidence:
|
Faulty equipment is identified and tagged according to workplace procedures Completed |
Evidence:
|
Operator maintenance is completed according to manufacturer and component supplier specifications and workplace procedures Completed |
Evidence:
|
Tools are maintained according to workplace procedures Completed |
Evidence:
|