The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare for fabrication work
|
|
Information for work is accessed from manufacturer/ component supplier specifications and interpreted. Completed |
Evidence:
|
WHS requirements, including personal protection needs, are observed throughout the work. Completed |
Evidence:
|
Materials are selected and inspected for quality. Completed |
Evidence:
|
Components, tooling and equipment for fabrication and installation are identified, selected and prepared in accordance with worksite procedures. Completed |
Evidence:
|
Procedures are determined to minimise waste material. Completed |
Evidence:
|
Procedures are identified for maximising energy efficiency while completing the job. Completed |
Evidence:
|
Measure, mark out and cut floor coverings material
|
|
Information for measuring, marking out and cutting is interpreted and followed. Completed |
Evidence:
|
Measurements are accessed from manufacturer/component supplier specifications and/or directly measured fitting requirements. Completed |
Evidence:
|
Marking out and cutting are carried out and completed in accordance with work plan and specifications. Completed |
Evidence:
|
Measurements, marking out and cutting are checked for conformity to specifications in accordance with worksite procedures. Completed |
Evidence:
|
Make up/assemble floor coverings
|
|
Information for following production processes is accessed from manufacturer/component supplier specifications, interpreted and followed. Completed |
Evidence:
|
Make up/assembly of floor coverings is carried out and completed in accordance with work plan and specifications. Completed |
Evidence:
|
Damage to equipment or machinery is avoided. Completed |
Evidence:
|
Production is checked for conformity to specifications in accordance with worksite procedures. Completed |
Evidence:
|
Install and fasten vehicle floor coverings
|
|
Information for installation and fastening is interpreted and followed. Completed |
Evidence:
|
Installation and fastening processes and methods are accessed from manufacturer/component supplier specifications and/or determined from existing fitting. Completed |
Evidence:
|
Installation and fastenings are checked for conformity to manufacturer/component supplier specifications and vehicle operational requirements. Completed |
Evidence:
|
Clean up work area and maintain equipment
|
|
Material that can be reused is collected and stored. Completed |
Evidence:
|
Waste and scrap is removed following workplace procedure. Completed |
Evidence:
|
Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures. Completed |
Evidence:
|
Unserviceable equipment is tagged and faults identified in accordance with workplace procedures. Completed |
Evidence:
|
Operator maintenance is completed in accordance with manufacturer/component supplier specifications and worksite procedures. Completed |
Evidence:
|
Tooling is maintained in accordance with workplace procedures. Completed |
Evidence:
|