The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Plan and prepare.
|
|
Work instructions, including plans, specifications, quality requirements and operational details, are obtained, confirmed and applied from relevant information for planning and preparation. Completed |
Evidence:
|
Safety (OHS) requirements are followed in accordance with safety plans and policies. Completed |
Evidence:
|
Signage and barricade requirements are identified and implemented. Completed |
Evidence:
|
Plant, tools and equipment selected to carry out tasks are consistent with job requirements, checked for serviceability, and any faults are rectified or reported prior to commencement. Completed |
Evidence:
|
Material quantity requirements are calculated in accordance with plans and specifications. Completed |
Evidence:
|
Materials appropriate to work application are identified, obtained, prepared, safely handled and located ready for use. Completed |
Evidence:
|
Environmental requirements are identified for the project in accordance with environmental plans and statutory and regulatory authority obligations, and are applied. Completed |
Evidence:
|
Set out fasteners.
|
|
Minimum distances for set out from edge of substrate material are adhered to in accordance with legislation, regulations and codes of practice. Completed |
Evidence:
|
Material is located and temporarily held or fixed into designed position according to detailed drawings. Completed |
Evidence:
|
Use EPT.
|
|
EPT is checked for operation according to manufacturer specifications and safety (OHS) requirements for use of EPT. Completed |
Evidence:
|
Fastener is selected according to requirements of job. Completed |
Evidence:
|
Charge is selected to assessed requirements for material, base and penetration. Completed |
Evidence:
|
Attachments and accessories are installed to EPT in accordance with manufacturer specifications and safety (OHS) requirements. Completed |
Evidence:
|
Fastener and charge in EPT are located to manufacturer specifications. Completed |
Evidence:
|
EPT operation is carried out and fastener is fixed into place in accordance with manufacturer recommendations, legislation, regulations and codes of practice. Completed |
Evidence:
|
Fastening penetration is checked and appropriate depth into material is applied. Completed |
Evidence:
|
Power regulating device is adjusted for conditions. Completed |
Evidence:
|
Misfire procedures are carried out according to manufacturer recommendations, legislation, regulations and codes of practice. Completed |
Evidence:
|
Temporary holding and fixings are removed without damage to material. Completed |
Evidence:
|
Secure and store equipment and charges.
|
|
Charges are stored in designated container in accordance with legislation, regulations and codes of practice and used charges are recorded. Completed |
Evidence:
|
Unused fasteners, the EPT and attachments are stored in a carry case in line with manufacturer recommendations. Completed |
Evidence:
|
Logbook is checked and maintenance recorded according to manufacturer recommendations. Completed |
Evidence:
|
Maintain EPT and kit.
|
|
Safety features of tools are checked for serviceability in accordance with manufacturer operating manual. Completed |
Evidence:
|
Tools are cleaned and lubricated to manufacturer recommendations. Completed |
Evidence:
|
Periodic maintenance service is carried out to manufacturer specifications. Completed |
Evidence:
|
Diminished stocks of charges and fasteners are replenished to designed effectiveness of EPT kit. Completed |
Evidence:
|
Clean up.
|
|
Work area is cleared and materials disposed of, reused or recycled in accordance with legislation, regulations, codes of practice and job specification. Completed |
Evidence:
|
Plant, tools and equipment are cleaned, checked, maintained and stored in accordance with manufacturer recommendations and standard work practices. Completed |
Evidence:
|