The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Identify gas detection system requirements.
|
|
Plans, specifications and any special instructions are obtained. Completed |
Evidence:
|
Safety (OHS) requirements associated with the installation of gas detection systems, and workplace environmental requirements, are adhered to throughout the work. Completed |
Evidence:
|
Quality assurance requirements for company operations are identified and adhered to. Completed |
Evidence:
|
System design requirements are determined from design drawing or given information. Completed |
Evidence:
|
Compliance of the design, including selected gas detection system unit, system setout and location of detection unit and its sensors is confirmed. Completed |
Evidence:
|
Design faults are reported in accordance with fault reporting workplace requirements and corrective action is taken. Completed |
Evidence:
|
Prepare for installation.
|
|
Materials, equipment and cylinders are ordered and checked for compliance with docket and order form, and for acceptable condition. Completed |
Evidence:
|
Appropriate tools and equipment for the installation, including personal protective equipment, are identified and selected. Completed |
Evidence:
|
Work is planned in conjunction with others involved in or affected by the work. Completed |
Evidence:
|
Work area and materials are prepared to support efficient installation of the system. Completed |
Evidence:
|
Install and test gas detection system.
|
|
Gas detection system is installed in relation to appliances and bilge or lowest point of the craft in accordance with appropriate statutory and regulatory authority requirements and compliance with standards and job specifications. Completed |
Evidence:
|
Low voltage wiring is installed in accordance with manufacturer instructions. Completed |
Evidence:
|
Consumer instruction plates and labels are positioned in accordance with standards and workplace requirements. Completed |
Evidence:
|
System is adjusted to comply with standards. Completed |
Evidence:
|
Selected test equipment is appropriate for the work and system is tested in accordance with standards. Completed |
Evidence:
|
Test data is recorded in format required by authority or job specification. Completed |
Evidence:
|
Clean up.
|
|
Work area is cleared and materials disposed of or recycled in accordance with state or territory statutory and regulatory authority legislation and workplace procedures. Completed |
Evidence:
|
Tools and equipment are cleaned, checked, maintained and stored in accordance with manufacturer recommendations and workplace procedures. Completed |
Evidence:
|
Information is accessed and documentation completed in accordance with workplace requirements. Completed |
Evidence:
|