The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare for work.
|
|
Plans and specifications are obtained and confirmed by site inspection. Completed |
Evidence:
|
Safety (OHS) requirements associated with fabricating and installing external flashings, and workplace environmental requirements, are adhered to throughout the work. Completed |
Evidence:
|
Quality assurance requirements are identified and adhered to in accordance with workplace requirements. Completed |
Evidence:
|
Tasks are planned and sequenced in conjunction with others involved in or affected by the work and statutory and regulatory authority requirements. Completed |
Evidence:
|
Tools and equipment, including personal protective equipment, are selected and checked for serviceability. Completed |
Evidence:
|
Work area is prepared to support efficient fabrication and installation of external flashings. Completed |
Evidence:
|
Identify installation requirements.
|
|
External flashings to be installed are identified and working drawings and patterns are developed from job drawings, plans, specifications, site measurements and relevant information. Completed |
Evidence:
|
Materials, coatings, fixings, sealants and fasteners are checked for compliance with plans, specifications and standards and are compatible with adjacent materials and catchment. Completed |
Evidence:
|
Materials are identified, ordered and collected in accordance with workplace procedures. Completed |
Evidence:
|
Materials and equipment are checked for compliance with docket and order form and for acceptable condition, and faults are reported. Completed |
Evidence:
|
Fabricate and install external flashings.
|
|
External flashings are fabricated in compliance with standards, drawings, specifications and site measurements. Completed |
Evidence:
|
Support framework is set out where required and fixed to comply with plans, specifications and manufacturer recommendations. Completed |
Evidence:
|
Thermal insulation, where required, is set and fixed in accordance with plans, specifications and cladding manufacturer's recommendations. Completed |
Evidence:
|
Clean up.
|
|
Work area is cleared and materials disposed of or recycled in accordance with state and territory legislation and workplace procedures. Completed |
Evidence:
|
Tools and equipment are cleaned, checked, maintained and stored in accordance with manufacturer recommendations and workplace procedures. Completed |
Evidence:
|
Documentation is completed in accordance with workplace requirements. Completed |
Evidence:
|