The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare for work.
|
|
Plans and specifications are obtained. Completed |
Evidence:
|
Safety (OHS) requirements associated with selecting and installing industrial roof components, and workplace environmental requirements, are adhered to throughout the work. Completed |
Evidence:
|
Quality assurance requirements are identified and adhered to in accordance with workplace requirements. Completed |
Evidence:
|
Tasks are planned and sequenced in conjunction with others involved in or affected by the work and statutory and regulatory authority requirements. Completed |
Evidence:
|
Tools and equipment, including personal protective equipment, are selected and checked for serviceability. Completed |
Evidence:
|
Work area is prepared to support efficient selection and installation of industrial roof components. Completed |
Evidence:
|
Identify installation requirements.
|
|
Industrial roof components are identified from plans and specifications and are compatible with adjacent materials and other relevant information. Completed |
Evidence:
|
Proposed sealant, fixing materials, and roofing and flashing materials are selected and checked for compliance with plans, specifications and relevant Australian standards. Completed |
Evidence:
|
Materials are identified, ordered and collected in accordance with workplace procedures. Completed |
Evidence:
|
Materials and equipment are checked for compliance with docket and order form and for acceptable condition, and faults are reported. Completed |
Evidence:
|
Sustainability principles and concepts are applied to work preparation and application. Completed |
Evidence:
|
Location of installation and opening size are identified from plans and manufacturer specifications. Completed |
Evidence:
|
Location is checked for obstructions that may affect the installation. Completed |
Evidence:
|
Install roof components.
|
|
Where required, the industrial component is erected to comply with manufacturer recommendations. Completed |
Evidence:
|
Industrial roof component is set out to comply with plans, specifications and site measurements. Completed |
Evidence:
|
Structural supports are installed to comply with plans and specifications. Completed |
Evidence:
|
Openings are prepared to comply with plans, specifications and relevant Australian standards. Completed |
Evidence:
|
Mullions, frames, baffles, sheeting and louvre blades are located and fixed to comply with manufacturer recommendations. Completed |
Evidence:
|
Component is installed to comply with plans, specifications and manufacturer requirements. Completed |
Evidence:
|
Flashing and waterproofing, including proprietary or purpose-made flashing, are installed to comply with relevant Australian standards, plans, specifications, manufacturer recommendations and regulatory authorities' requirements. Completed |
Evidence:
|
Installation is performance tested and remedied as required. Completed |
Evidence:
|
Clean up.
|
|
Work area is cleared and materials disposed of, reused or recycled according to legislation, regulations, codes of practice and job specification. Completed |
Evidence:
|
Tools and equipment are cleaned, checked, maintained and stored in accordance with manufacturer recommendations and workplace procedures. Completed |
Evidence:
|
Documentation is completed in accordance with workplace requirements. Completed |
Evidence:
|