The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Set up equipment
|
|
Applicable occupational health and safety (OHS), environmental, legislative and organisational requirements relevant to swaging and shaping saw blades are identified and followed Completed |
Evidence:
|
Required swage shape and thickness are acquired from existing saws and relevant information Completed |
Evidence:
|
Saw, swage and shaping equipment are set up in line with enterprise requirements Completed |
Evidence:
|
Die or swage clamp/vice shape is checked against the required shape, clearances and kerf, and changed where necessary to suit Completed |
Evidence:
|
Saw is secured in a swage clamp/vice or swager with teeth aligned to the swager or vice shape Completed |
Evidence:
|
Anti-scuffing paste is applied to the areas of the saw that will be swaged Completed |
Evidence:
|
Communication with others is established and maintained in line with OHS requirements Completed |
Evidence:
|
Swage teeth
|
|
Trial swage is completed and swaging setup checked Completed |
Evidence:
|
Successful trial swage is included in the process and unsuccessful trial swage is dealt with in line with site procedures and environmental requirements Completed |
Evidence:
|
Swage shape and thickness are inspected and measuring equipment is used for tangential and radial, clearance and kerf Completed |
Evidence:
|
Swaging operation is adjusted in line with manufacturer recommendations and job specifications Completed |
Evidence:
|
Dies are checked for wear and adjusted in line with manufacturer recommendations and site procedures Completed |
Evidence:
|
Remaining teeth are swaged in line with job specifications Completed |
Evidence:
|
Shape teeth
|
|
Excess material resulting from swaging process is filed and shaped Completed |
Evidence:
|
Trial shape is completed and tooth tolerances are checked and adjusted where necessary Completed |
Evidence:
|
Successful trial shape is included in the process and unsuccessful trial shape is dealt with in line with site procedures and environmental requirements Completed |
Evidence:
|
Shape is assessed and adjustments are made to meet site procedures Completed |
Evidence:
|
Remaining teeth are shaped in line with job specifications and tooth alignment is checked Completed |
Evidence:
|
Swaging process and equipment faults are recorded and reported to appropriate personnel Completed |
Evidence:
|