The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare for reconditioning
|
|
Applicable Occupational Health and Safety (OHS), environmental, legislative and organisational requirements relevant to reconditioningband mill wheels are identified and followed Completed |
Evidence:
|
Work order is reviewed and checked with appropriate personnel Completed |
Evidence:
|
Equipment is selected appropriate to work requirements and checked for operational effectiveness in line with manufacturer's recommendations Completed |
Evidence:
|
Reconditioning process is planned in line with site procedures and environmental requirements Completed |
Evidence:
|
Communication with others is established and maintained in line with OHS requirements Completed |
Evidence:
|
Fit and grind wheel profile
|
|
Wheel is inspected and measured to identify wear and method of grinding Completed |
Evidence:
|
Wheel grinder is serviced, fitted and aligned to the band mill and wheel in line with manufacturer's specifications and recommended tolerances Completed |
Evidence:
|
Trial cut is taken to check and further align the grinder Completed |
Evidence:
|
Wheel is ground until all signs of wear are removed, ensuring the face is not hollow and obtaining the required wheel profile and finish Completed |
Evidence:
|
Grinding feeds are controlled to obtain the required profile Completed |
Evidence:
|
Wheel is measured to ensure the diameter of back and front edges are equivalent Completed |
Evidence:
|
Wheel profile is measured to ensure grinding has achieved the required profile Completed |
Evidence:
|
Grinder traversing speeds are controlled to obtain the required profile Completed |
Evidence:
|
Reassemble band mill
|
|
Grinder and base plate are removed from band mill at completion of grinding Completed |
Evidence:
|
Band mill components are reassembled to manufacturer's specifications Completed |
Evidence:
|
Band saw is set up on mill to specified alignment Completed |
Evidence:
|
Band saw and mill operation are tested to ensure correct operation Completed |
Evidence:
|
Isolation padlocks or tags are removed at completion of the work in line with OHS legislation and site procedures Completed |
Evidence:
|
Band saw mills damaged during the process that cannot be repaired are disposed of in line with site procedures and environmental requirements Completed |
Evidence:
|
Reconditioning process and equipment faults are investigated, recorded and reported in line with site requirements Completed |
Evidence:
|