The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare for application
|
|
Applicable Occupational Health and Safety (OHS), environmental, legislative and organisational requirements relevant to laminating and veneering board surfaces are identified and followed Completed |
Evidence:
|
Work order is reviewed and checked with appropriate personnel Completed |
Evidence:
|
Type and quantity of laminate or veneer and board to be adhered is acquired from the production process Completed |
Evidence:
|
Equipment is selected appropriate to work requirements and checked for operational effectiveness in line with manufacturer's recommendations Completed |
Evidence:
|
Production process is selected in line with site procedures Completed |
Evidence:
|
Communication with others is established and maintained in line with OHS requirements Completed |
Evidence:
|
Apply laminate or veneer
|
|
Pre start-up checks are carried out on equipment in line with site requirements Completed |
Evidence:
|
Veneer or laminate and board are loaded and fed to suit planned assembly in the correct sequence Completed |
Evidence:
|
Spreader stations are adjusted to provide material delivery in line with required board cross-section distribution Completed |
Evidence:
|
Glue feed, spread and tack levels are regularly adjusted to apply glue to board evenly and ensure it remains free from foreign material likely to cause contamination Completed |
Evidence:
|
Heat rolling process is regularly checked to prevent creases, bubbles or other surface defects Completed |
Evidence:
|
Laminate or veneer is routinely monitored for position, adhesion, contamination, finish and trim tolerances Completed |
Evidence:
|
Finished panels are transferred for further processing in line with site requirements Completed |
Evidence:
|
Processing and equipment faults are recorded and reported to the appropriate personnel Completed |
Evidence:
|
Sub-standard material is rejected and disposed of in line with site procedures and environmental requirements Completed |
Evidence:
|
Shut down and clean equipment
|
|
Shutdown procedures are coordinated with other line operators and followed in line with OHS legislation and site procedures Completed |
Evidence:
|
Gluing equipment, rollers, cauls, screens and handling equipment are stripped, cleaned and replaced if necessary in line with site operating procedures Completed |
Evidence:
|
Cutters or blades are checked for blunt or damaged condition Completed |
Evidence:
|
Cutters or blades are removed and replaced in line with manufacturer's recommendations Completed |
Evidence:
|
Machine area is kept clear of foreign material, dust and debris in line with OHS requirements Completed |
Evidence:
|