The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Set up and prepare for installation
|
|
Obtain relevant legislation, codes, regulations and standards for compliance when conducting work Completed |
Evidence:
|
Scope the work by obtaining project plan from appropriate personnel and arrange for site access to comply with security arrangements Completed |
Evidence:
|
Notify appropriate personnel of identified safety hazards at the work site Completed |
Evidence:
|
Determine type of FDH enclosure and optical splitter module from project plan and identify splitter installation requirements using work instructions Completed |
Evidence:
|
Obtain tools and safety equipment and material to perform tasks safely and efficiently Completed |
Evidence:
|
Select and use required protective equipment and make site safe and secure for installation work Completed |
Evidence:
|
Obtain splitter module and visually inspect for splitter module damage and replace if necessary Completed |
Evidence:
|
Install splitter module in FDH
|
|
Follow occupational health and safety (OHS) and environmental requirements for the given work and identify and avoid other services Completed |
Evidence:
|
Open the enclosure and asses the suitability of the FDH according to the project plan Completed |
Evidence:
|
Locate next available slot in splitter module area of FDH for installation Completed |
Evidence:
|
Insert splitter module and secure according to manufacturer's specifications Completed |
Evidence:
|
Inspect installed splitter module and surrounding area for completeness of job Completed |
Evidence:
|
Prepare and connect splitter input fibres to feeder cable
|
|
Locate feeder port to be connected and remove protective cover in preparation Completed |
Evidence:
|
Use an optical power meter to verify feeder port is not active Completed |
Evidence:
|
Clean the adapter according to manufacturer's specifications and route splitter input fibre to correct feeder port Completed |
Evidence:
|
Remove dust cap and clean end face according to manufacturer's specifications to prevent possible damage from mating contaminated connectors Completed |
Evidence:
|
Connect input fibre to feeder port and record connection according to organisational policy Completed |
Evidence:
|
Connect output fibres and test splitter
|
|
Determine output fibre to be connected and required adapter in distribution field Completed |
Evidence:
|
Clean adapter and fibre end-face according to manufacturer's specifications Completed |
Evidence:
|
Route output fibre and connect with adapter in distribution field Completed |
Evidence:
|
Test operation of optical splitter for optical power levels at the operating WDM optical wavelengths Completed |
Evidence:
|
Record connections, test results and park unused fibre leads for safety reasons according to organisational policy Completed |
Evidence:
|
Clean up work site
|
|
Seal any internal enclosures and close FDH Completed |
Evidence:
|
Remove installation waste and debris from worksite and dispose of according to environmental requirements Completed |
Evidence:
|
Notify appropriate personnel of job completion and obtain sign off Completed |
Evidence:
|