Prepare to install and splice hard-line coaxial cable

1. Confirm site access approval prior to site entry and comply with site security arrangements
2. Read and interpret installation specifications and physical conditions at site to determine job layout
3. Locate and identify adjoining other services according to industry guidelines, and work health and safety (WHS) practices
4. Test for and respond to presence of dangerous gases in underground enclosures according to industry guidelines
5. Test relevant aerial metallic fittings for live voltage and respond according to industry guidelines
6. Install equipotential bonding according to design
7. Undertake approved alterations to design, as required, according to industry guidelines
8. Select appropriate hard-line coaxial cable type according to installation requirements
9. Select and obtain all materials required for cable termination including passive and active devices and connectors

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Verify placement and secure coaxial cable

1. Use safety equipment to protect self and public according to industry guidelines and WHS requirements
2. Protect integrity of coaxial cable (sheath, shield and centre conductor) to ensure no loss of performance
3. Form cable into position with sufficient lengths by using approved forming tools that allow termination and maintain minimum bend radius according to manufacturer specifications
4. Follow installation design to install cable safely without damage to cable and ensure cable flow in pits and manholes is according to carrier standards and work instructions
5. Maintain radio frequency (RF) signal strength by installing cable lengths within manufacturer or design specifications
6. Locate securing hardware to reduce cumulative effect on cable wave shape properties
7. Use correct lashing machine and techniques to attach aerial cable to catenary wire

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Splice coaxial cable

1. Strip and core hard-line coaxial cable, according to specifications, to required length using appropriate tools
2. Select appropriate kit to match type of hard-line coaxial cable in use and splice according to manufacturer recommendations
3. Seal all splices according to industry specifications

Completed
Date:

Completed
Date:

Completed
Date:

Terminate coaxial cable

1. Prepare coaxial cable for termination, according to specifications, using appropriate tools
2. Select connectors to match type of coaxial cable in use and terminate according to industry standards
3. Install network device chassis/housing in correct orientation according to design
4. Prepare centre pins of cable and connector, and cut according to vendor specifications
5. Terminate connectors to torque according to manufacturer recommendations to prevent RF leakage, and ensure seizure screws are tightened
6. Seal all terminations according to industry specifications

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Complete installation operation

1. Place cables in pit and/or mount on aerial strand according to manufacturer instructions and industry guidelines, and check that no safety hazards are evident
2. Attach fitted off device aerially or underground according to manufacturer specifications or work instructions
3. Reinstate site, and remove waste and debris for disposal according to environmental requirements and maintain safe worksite conditions

Completed
Date:

Completed
Date:

Completed
Date:

Complete installation administration

1. Complete reports according to telecommunications carrier network policy
2. Update plans and records using appropriate symbols with details of installation

Completed
Date:

Completed
Date: