The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Assess different qualities and types of materials
|
|
Materials are assessed against job specifications. Completed |
Evidence:
|
Various types and finish of materials are checked according to work ticket. Completed |
Evidence:
|
Materials are inspected and sorted according to colours, shades and finish. Completed |
Evidence:
|
Materials that cannot be matched are handled and stored. Completed |
Evidence:
|
Start up, shut down, adjust and carry out minor maintenance with safety
|
|
Machines are started up and shut down according to safety regulations. Completed |
Evidence:
|
Cutting board is regularly cleaned, turned and maintained. Completed |
Evidence:
|
Striker plate is regularly checked for distortion and damage and irregularities reported. Completed |
Evidence:
|
Cut linings and components from materials by press or hand
|
|
Knives are selected according to job specifications and size requirements and used according to OHS practices. Completed |
Evidence:
|
Pressures on press are adjusted to knife sizes and shapes. Completed |
Evidence:
|
Work ticket specifications are followed according to pairs and pieces. Completed |
Evidence:
|
Parts are cut to workplace quality standards in relation to materials flaws and acceptable levels of matching of irregular and non-uniform finishes. Completed |
Evidence:
|
Decisions are made about individual pairs based on colour and grain approximation according to workplace quality standards. Completed |
Evidence:
|
Pairs are cut to appropriate allowances, to achieve best yield and best matching of materials. Completed |
Evidence:
|
Distortions and defects on press cutting knives, dies and cutting boards are identified and appropriate action taken. Completed |
Evidence:
|
Work is carried out according to OHS practices. Completed |
Evidence:
|
Check finished product
|
|
Finished product is checked against workplace quality standards. Completed |
Evidence:
|
Failure to meet quality standards is addressed. Completed |
Evidence:
|