The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare for shot-peening task
|
|
Obtain and interpret process documentation requirements Completed |
Evidence:
|
Prepare shot-peening equipment in accordance with the applicable process Completed |
Evidence:
|
Apply shot-peening process to Almen strip
|
|
Select and fit the correct Almen strip and set up equipment with the correct stand-off distance and regulated air pressure or spindle speed in accordance with the process documentation Completed |
Evidence:
|
Implement applicable work health and safety (WHS) provisions, including the use of material safety data sheets (MSDSs) and personal protective equipment (PPE) Completed |
Evidence:
|
Apply the process to the Almen strip Completed |
Evidence:
|
Measure the Almen strip distortion to ensure that it is within the specified tolerance Completed |
Evidence:
|
Adjust equipment settings and repeat the Almen strip test when required Completed |
Evidence:
|
Record settings that produce specified Almen strip distortion and present the test strip for inspection Completed |
Evidence:
|
Apply shot-peening process to component
|
|
Clean and mask the component in accordance with process documentation Completed |
Evidence:
|
Apply shot-peening in accordance with the process documentation using equipment settings derived from Almen test strip and while observing all WHS requirements, including use of MSDSs and PPE Completed |
Evidence:
|
Check the shot peened surface for required density and coverage and re-peen, when required Completed |
Evidence:
|
Check the shot-peened component for cleanliness to ensure that all contaminants have been removed in accordance with the process documentation Completed |
Evidence:
|
Complete shot-peening task
|
|
Record task completion in accordance with standard enterprise procedures Completed |
Evidence:
|
Present shot-peened component for inspection, along with Almen test strip and completed documentation Completed |
Evidence:
|
Tag, seal and pack the component, where applicable and in accordance with specified procedures Completed |
Evidence:
|
Dispose of waste shot peening media in accordance with procedures Completed |
Evidence:
|