The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare CMM
|
|
Determine probe configuration according to specifications Completed |
Evidence:
|
Adjust probe configuration on CMM according to SOPs Completed |
Evidence:
|
Check probe angles for compliance and adjust, as required Completed |
Evidence:
|
Re-calibrate CMM Completed |
Evidence:
|
Align probes manually for one-off components Completed |
Evidence:
|
Measure components
|
|
Edit part program to compensate for errors or changes to component specifications Completed |
Evidence:
|
Measure components and check for conformance to specification Completed |
Evidence:
|
Produce data/report Completed |
Evidence:
|
Determine job requirements
|
|
Follow standard operating procedures (SOPs) Completed |
Evidence:
|
Comply with work health and safety (WHS) requirements at all times |
|
Completed |
Evidence:
|
Use appropriate personal protective equipment (PPE) in accordance with SOPs |
|
Completed |
Evidence:
|
Interpret drawing information and a range of tolerances that apply to components and establish datums |
|
Completed |
Evidence:
|
Set up/orient components
|
|
Undertake pre-start checks in accordance with SOPs Completed |
Evidence:
|
Observe correct safety procedures and check all equipment for safe operation |
|
Completed |
Evidence:
|
Determine the most appropriate method of clamping/support to minimise distortion and maximise measuring access |
|
Completed |
Evidence:
|
Set up and orient component/fixture/clamping devices |
|
Completed |
Evidence:
|
Select and activate part programs
|
|
Identify and verify part program, as required Completed |
Evidence:
|
Activate selected part program in accordance with SOPs
|
|
Determine probe configuration according to specifications Completed |
Evidence:
|
Adjust probe configuration on CMM according to SOPs |
|
Completed |
Evidence:
|
Check probe angles for compliance and adjust, as required |
|
Completed |
Evidence:
|
Align probes manually for one-off components
|
|
Edit part program to compensate for errors or changes to component specifications Completed |
Evidence:
|
Measure components and check for conformance to specification |
|
Completed |
Evidence:
|