The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Access and interpret fault codes
|
|
Applicable control unit is located and identified. Completed |
Evidence:
|
Fault codes are accessed using vehicle indicators, meters and diagnostic tooling. Completed |
Evidence:
|
Fault codes are interpreted. Completed |
Evidence:
|
Fault codes are cleared from memory according to procedures. Completed |
Evidence:
|
Diagnostic and maintenance procedures are performed using applicable techniques and precautions to safeguard electronic components and systems. Completed |
Evidence:
|
Locate and rectify faults using fault codes and manufactures fault finding and rectification procedures
|
|
Fault is traced from fault codes using applicable troubleshooting procedures. Completed |
Evidence:
|
Faults are rectified to required specification. Completed |
Evidence:
|
Locate and test input components
|
|
Input components are located and identified. Completed |
Evidence:
|
Input components are electrically tested. Completed |
Evidence:
|
Locate and test output components
|
|
Output components are located and identified. Completed |
Evidence:
|
Output components electrically tested. Completed |
Evidence:
|
Remove/replace and adjust sensors and actuators
|
|
Component part is removed correctly. Completed |
Evidence:
|
Correct replacement part is identified. Completed |
Evidence:
|
Component part replaced correctly. Completed |
Evidence:
|
Adjustments are made in relation to mechanical clearances and measured electrical and resistance values. Completed |
Evidence:
|
Change operating parameters
|
|
Appropriate specifications are sourced from plant/equipment identification and applicable manuals and specifications. Completed |
Evidence:
|
Appropriate tooling (software/hardware) is selected. Completed |
Evidence:
|
Plant/equipment identification is used to obtain security codes. Completed |
Evidence:
|
Data is downloaded. Completed |
Evidence:
|
Data is entered for new specifications. Completed |
Evidence:
|
Successful data entry is verified. Completed |
Evidence:
|