The range statement relates to the unit of competency as a whole. It allows for different work environments and situations that may affect performance. Bold italicised wording, if used in the performance criteria, is detailed below. Essential operating conditions that may be present with training and assessment (depending on the work situation, needs of the candidate, accessibility of the item, and local industry and regional contexts) may also be included. |
Procedures | Procedures may be written, verbal, computer-based or in some other form, and may include: all work instructions standard operating procedures formulas/recipes batch sheets temporary instructions any similar instructions provided for the smooth running of the plant good operating practice as may be defined by industry codes of practice (e.g. Responsible Care) and government regulations |
Resin chemistry | Resin chemistry includes: process of curing/cross linking of resins rate of cure and change of properties over cure time changes in viscosity and other flow properties during progress of cure final properties of resin post-cure |
Environmental changes | Environmental changes may include: temperature humidity air flow/wind solar/ultraviolet (UV) insolation |
Resin composition | Resin composition includes: resin/catalyst ratio resin/promoter ratio resin/catalyst/promoter ratios changing temperature of resin components (e.g. using chilled catalyst or resin) ratios of other resin system components |
Most appropriate resin composition changes | Most appropriate resin composition changes refers to those resin system changes which: comply with product requirements adjust for the current conditions have greatest ease of use in manufacture have best financial return have greatest sustainability contribution |
Appropriate action | Appropriate action may include, but is not limited to: making any required changes to resin composition changes deferring the fabrication until more suitable conditions prevail |
Sustainability | Sustainability incorporates the three aspects of: survival of the ecology/physical environment – which means that an enterprise needs to manage the impact of the business to ensure the survival of the physical environment economic viability – efficiency, cost and waste reduction and competitiveness to support survival of the business social sustainability – an enterprise needs to manage the impact of the business to ensure its continued survival within the community and the survival of the community, including occupational health and safety (OHS) |
Alternative process changes | Alternative process changes may include: controlling the environmental conditions moving the timing of the job to when conditions are more favourable (e.g. at night) moving the location of the job to where conditions are more favourable (e.g. in plant, different site and in shade) |
Logs and reports | Logs and reports may include: paper or electronic based verbal reports items found which require action |
Appropriate action | Appropriate action includes: determining problems needing action determining possible fault causes rectifying problem using appropriate solution within area of responsibility following through items initiated until final resolution has occurred reporting problems outside area of responsibility to designated person |
Typical problems | Typical problems may include: unusually hot/cold workplace/weather extreme humidity very tight/unusual specification of properties required of product high/low air flow/wind |
Health, safety and environment (HSE) | All operations to which this unit applies are subject to stringent HSE requirements, which may be imposed through state/territory or federal legislation, and these must not be compromised at any time. Where there is an apparent conflict between Performance Criteria and HSE requirements, the HSE requirements take precedence |