The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare for work
|
|
Work instructions are used to determine job requirements for a basic glass and glazing job, including design variations, tolerances, process, materials, finish and quantity Completed |
Evidence:
|
Work sequence is planned and procedures are determined for checking quality at each stage of the process Completed |
Evidence:
|
Work health and safety requirements (WHS), including personal protective equipment, are observed throughout the work Completed |
Evidence:
|
Preparatory drawings/set-outs for tasks are confirmed and a suitable work area selected Completed |
Evidence:
|
Materials are selected following work instructions Completed |
Evidence:
|
Tools and equipment and a table suitable for the work are identified and checked for safe and effective operation Completed |
Evidence:
|
Fabricate and assemble components
|
|
Material is set out according to work instructions, prepared, and components marked according to workplace procedures Completed |
Evidence:
|
Tools, machines and equipment are used in accordance with safety requirements and manufacturer specifications Completed |
Evidence:
|
Components are fabricated, including any specified shapes, angles or curves, and checked against set-out and job requirements Completed |
Evidence:
|
Components are fitted to job requirements and the assembly process undertaken according to workplace procedures Completed |
Evidence:
|
Item is checked for compliance with specifications and finished in accordance with work instructions using edging equipment, where required Completed |
Evidence:
|
Finalise operation and maintain equipment
|
|
Work area is cleaned, hand and/or power tools and equipment are cleaned, maintained and stored in accordance with workplace procedures Completed |
Evidence:
|
Off-cuts and unused materials are collected and stored for re-use or disposed of following workplace procedures Completed |
Evidence:
|
Waste and scrap materials are dealt with following workplace procedures Completed |
Evidence:
|