The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Identify work requirements
|
|
Work requirements in the form of type of glass, frames and the method of fixing are identified from work instructions Completed |
Evidence:
|
Work health and safety (WHS) requirements for fabrication and installation of commercial glazing, including personal protective equipment, are identified and observed throughout the work Completed |
Evidence:
|
Process for fabricating and installing commercial flat and/or curved glazing is determined Completed |
Evidence:
|
Prepare for work
|
|
Work sequence is planned in a logical order to suit the job and workplace procedures Completed |
Evidence:
|
Tools, equipment and materials, other than glass and frames, are selected and checked prior to use to ensure they are appropriate for the work, serviceable and in a safe condition Completed |
Evidence:
|
Type of glass to be fitted and frames are selected to match the customer order Completed |
Evidence:
|
Glass is checked for type, size and imperfections Completed |
Evidence:
|
Glass fixing method and appropriate method of glazing are selected Completed |
Evidence:
|
Identify site conditions and constraints
|
|
Site safety hazards are recognised and corrective action taken to reduce injury to self and others Completed |
Evidence:
|
Other on-site difficulties are identified and corrective action taken in accordance with regulations and enterprise agreements Completed |
Evidence:
|
Special characteristics of the glass aperture are identified in relation to the effect of the glass fitting process on the finished job Completed |
Evidence:
|
Covering material is applied, where necessary, to protect existing fixtures and fittings Completed |
Evidence:
|
Prepare frame
|
|
Frame condition is assessed to ensure suitability for glazing in accordance with customer order and Australian Standards Completed |
Evidence:
|
Defective frames are reported for repair or replacement in accordance with workplace procedures Completed |
Evidence:
|
Frame is prepared, if required, to receive glass Completed |
Evidence:
|
Fixing and sealing materials are prepared by mixing or cutting to length, as appropriate Completed |
Evidence:
|
Fit glass
|
|
Glass is fixed to the frame using the selected method and in accordance with recognised Australian and industry standards Completed |
Evidence:
|
Solvents and sealants are used in accordance with manufacturer recommendations and Australian Standards Completed |
Evidence:
|
Excess sealing material is removed and the glass and frame are cleaned after fixing Completed |
Evidence:
|
Complete work
|
|
Completed installation is checked to ensure compliance with customer requirements, specifications and Australian Standards Completed |
Evidence:
|
Work area is cleaned and left in a safe condition and rubbish removed from work area and disposed of in accordance with relevant statutory requirements and workplace requirements Completed |
Evidence:
|
Tools, equipment and materials are cleaned and stored following workplace procedures Completed |
Evidence:
|
Waste and scrap material are removed for disposal or recycling, as required Completed |
Evidence:
|
Workplace documentation is completed in accordance with workplace requirements including calculating the cost of glass, fittings, materials and labour Completed |
Evidence:
|