The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Plan own work requirements.
|
|
Identify the most appropriate equipment to be used for production process, upstream and downstream operations from production plan or request. Completed |
Evidence:
|
Identify and check materials required, including additives and regrind and their amounts or percentages. Completed |
Evidence:
|
Implement measures to control identified hazards in line with procedures and duty of care. Completed |
Evidence:
|
Identify requirements for materials, quality, production and equipment checks. Completed |
Evidence:
|
Start up blow moulding equipment to procedures.
|
|
Identify process settings required for product. Completed |
Evidence:
|
Set up and adjust blow moulding equipment for shot size, parison control, die gap, temperature, screw speed, cycle speed, slow close setting (or cushion) and timing. Completed |
Evidence:
|
Check safety gates and guards are located in their correct working positions and emergency stops are identified and checked as required. Completed |
Evidence:
|
Verify equipment, raw material and mould all match job requirement. Completed |
Evidence:
|
Set up date, batch and materials markings. Completed |
Evidence:
|
Complete other pre-start checks. Completed |
Evidence:
|
Start up equipment safely and 'dry run' to warm hydraulics and components to operating temperature before production, as required. Completed |
Evidence:
|
Operate and make adjustments to the blow moulding process to procedures.
|
|
Check condition of equipment and introduce raw materials as required. Completed |
Evidence:
|
Operate blow moulding equipment, noting key variables Completed |
Evidence:
|
Monitor controls/displays/terminals for production and process data. Completed |
Evidence:
|
Monitor product/process quality. Completed |
Evidence:
|
Make adjustments to remedy faults and nonconformity as required. Completed |
Evidence:
|
Establish a stable blow moulding process. Completed |
Evidence:
|
Collect and reprocess/discard scrap/trim and other materials. Completed |
Evidence:
|
Clean, adjust and lubricate equipment as required. Completed |
Evidence:
|
Complete logs and records as required. Completed |
Evidence:
|
Pause or stop equipment in an emergency, as required. Completed |
Evidence:
|
Anticipate and solve problems.
|
|
Recognise a problem or a potential problem. Completed |
Evidence:
|
Determine problems needing priority action. Completed |
Evidence:
|
Refer problems outside area of responsibility to appropriate person, with possible causes. Completed |
Evidence:
|
Seek information and assistance as required to solve problems. Completed |
Evidence:
|
Solve problems within area of responsibility. Completed |
Evidence:
|
Follow through items initiated until final resolution has occurred. Completed |
Evidence:
|