The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Confirm product specifications
|
|
Confirm the conditions of use of the desired composite product Completed |
Evidence:
|
Confirm the required specification of the desired composite product Completed |
Evidence:
|
Determine any other special requirements of the desired composite product Completed |
Evidence:
|
Obtain client sign-off of specification/requirements Completed |
Evidence:
|
Select appropriate materials/process to produce the desired composite product
|
|
Identify the laminate properties suitable for the job Completed |
Evidence:
|
Select the appropriate resin, matrix and other materials Completed |
Evidence:
|
Select the process to be used to make product Completed |
Evidence:
|
Implement measures to control identified hazards in line with procedures and duty of care Completed |
Evidence:
|
Make trial samples where required and test or arrange testing of samples as required Completed |
Evidence:
|
Check suitability of combination of materials and process to meet all end use requirement Completed |
Evidence:
|
Complete pre-start checks Completed |
Evidence:
|
Lay up or mould the laminate
|
|
Prepare and apply mould release to the mould surface if required Completed |
Evidence:
|
Clean and prepare structure surface for adhesion if required Completed |
Evidence:
|
Apply laminate materials to the mould or to the structure as required Completed |
Evidence:
|
Inspect/test the laminate surface as required Completed |
Evidence:
|
Make adjustments to remedy faults and nonconformity as required Completed |
Evidence:
|
Adjust process to minimise scrap and waste Completed |
Evidence:
|
Clean, adjust and lubricate equipment as required Completed |
Evidence:
|
Anticipate and solve problems
|
|
Recognise a problem or a potential problem Completed |
Evidence:
|
Determine problems needing priority action Completed |
Evidence:
|
Determine possible fault causes Completed |
Evidence:
|
Solve problems within area of responsibility Completed |
Evidence:
|
Refer problems outside area of responsibility to designated person, with possible causes Completed |
Evidence:
|
Follow through items initiated until final resolution has occurred Completed |
Evidence:
|