The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Plan and prepare for casting operations
|
|
Access, interpret and apply compliance documentation relevant to the work activity Completed |
Evidence:
|
Receive, interpret and clarify shift change over details Completed |
Evidence:
|
Select personal protective equipment appropriate for work activities Completed |
Evidence:
|
Select appropriate type of equipment Completed |
Evidence:
|
Perform equipment pre-start checks Completed |
Evidence:
|
Carry out start-up procedures Completed |
Evidence:
|
Identify, address and report potential risks and hazards Completed |
Evidence:
|
Communicate with other equipment operators Completed |
Evidence:
|
Identify, address and report environmental issues Completed |
Evidence:
|
Adhere to emergency procedures Completed |
Evidence:
|
Ensure area is well ventilated Completed |
Evidence:
|
Mould, launder and ladle system is adjusted, to operate within specifications Completed |
Evidence:
|
Prepare moulds/launder system
|
|
Dress moulds/launder system Completed |
Evidence:
|
Check for defects against specifications Completed |
Evidence:
|
Prepare moulding pit according to site procedures Completed |
Evidence:
|
Dry product according to site procedures Completed |
Evidence:
|
Strip and cleanout moulding pit where required Completed |
Evidence:
|
Check cooling system for operation against specifications Completed |
Evidence:
|
Cast metal
|
|
Teem/tap liquid metal into ladles and/or launder system where required Completed |
Evidence:
|
Cast liquid metal to moulds Completed |
Evidence:
|
Take temperature and sample of the liquid to ensure pour meets specifications Completed |
Evidence:
|
Identify need for, and adjust composition of pour with additives Completed |
Evidence:
|
Monitor cast continuously Completed |
Evidence:
|
Remove cast metal
|
|
Knock off mould plates when mould has been bumped out Completed |
Evidence:
|
Repair launders where required Completed |
Evidence:
|
Identify and remove damaged and faulty mould Completed |
Evidence:
|
Remove slides from ladles, repair and reposition slides Completed |
Evidence:
|
Inspect for quality, chips and mark according to site procedures and quality parameters Completed |
Evidence:
|
Prepare ingots, anodes or bullion for transport and storage according to work plans Completed |
Evidence:
|
Shutdown in sequence and/or isolate equipment
|
|
Shutdown and/or isolate equipment based on process and safety requirements Completed |
Evidence:
|
Perform post shutdown and/or isolation checks Completed |
Evidence:
|
Carry out housekeeping activities
|
|
Clean equipment Completed |
Evidence:
|
Clean and store auxiliary services equipment Completed |
Evidence:
|
Pass on end of shift information to incoming shift Completed |
Evidence:
|
Complete all required documentation Completed |
Evidence:
|